OM25180FDKM Datasheet, PDF (1/149 Pages) NXP Semiconductors – High-performance multi-protocol full NFC Forum-compliant frontend

PN5180
High-performance multi-protocol full NFC Forum-compliant
frontend
Rev. 3.0 — 7 October 2016
240930
Product data sheet
COMPANY PUBLIC
1. Introduction
This document describes the functionality and electrical specification of the high-power
NFC IC PN5180.
Additional documents supporting a design-in of the PN5180 are available from NXP, this
information is not part of this document.
2. General description
PN5180, the best full NFC frontend on the market.
As a highly integrated high performance full NFC Forum-compliant frontend IC for
contactless communication at 13.56 MHz, this frontend IC utilizes an outstanding
modulation and demodulation concept completely integrated for different kinds of
contactless communication methods and protocols.
The PN5180 ensures maximum interoperability for next generation of NFC enabled
mobile phones. The PN5180 is optimized for point of sales terminal applications and
implements a high-power NFC frontend functionality which allows to achieve EMV
compliance on RF level without additional external active components.
The PN5180 frontend IC supports the following RF operating modes:
• Reader/Writer mode supporting ISO/IEC 14443-A up to 848 kBit/s, MIFARE
• Reader/Writer mode supporting ISO/IEC 14443-B up to 848 kBit/s
• Reader/Writer mode supporting JIS X 6319-4 (comparable with FeliCa scheme)
• Supports reading of all NFC tag types (type 1, type 2, type 3, type 4A and type 4B)
• Reader/Writer mode supporting ISO/IEC 15693
• Reader/Writer mode supporting ISO/IEC 18000-3 Mode 3
• ISO/IEC 18092 (NFC-IP1)
• ISO/IEC 21481 (NFC-IP-2)
• ISO/IEC 14443-type A Card emulation up to 848 kBit/s
One host interface based on SPI is implemented:
• SPI interface with data rates up to 7 Mbit/s with MOSI, MISO, NSS and SCK signals
• Interrupt request line to inform host controller on events
• EEPROM configurable pull-up resistor on SPI MISO line