THS4511 Datasheet, PDF (6/35 Pages) Texas Instruments – WIDEBAND, LOW NOISE, LOW DISTORTION FULLY DIFFERENTIAL AMPLIFIER

THS4511
SLOS471E – SEPTEMBER 2005 – REVISED NOVEMBER 2009
TYPICAL CHARACTERISTICS
Small-Signal Frequency
Response
Large-Signal Frequency
Response
Harmonic
Distortion
Intermodulation
Distortion
Output Intercept Point
S-Parameters
G = 0 dB, V_OD = 100 mV_PP
G = 6 dB, V_OD = 100 mV_PP
G = 0 dB, V_OD = 2 V_PP
G = 6 dB, V_OD = 2 V_PP
HD₂, G = 0 dB, V_OD = 2 V_PP
HD₃, G = 0 dB, V_OD = 2 V_PP
HD₂, G = 6 dB, V_OD = 2 V_PP
HD₃, G = 6 dB, V_OD = 2 V_PP
HD₂, G = 0 dB
HD₃, G = 0 dB
HD₂, G = 0 dB
HD₃, G = 0 dB
IMD₂, G = 0 dB
IMD₃, G = 0 dB
OIP₂
OIP₃
Transition Rate
Transient Response
Settling Time
Rejection Ratio
Output Impedance
Overdrive Recovery
Differential Output Voltage
Turn-Off Time
Turn-On Time
Input Offset Voltage
Open-Loop Gain and Phase
Input-Referred Noise
Noise Figure
Quiescent Current
Output Balance Error
CM Input Impedance
CM Small-Signal Frequency Response
CM Input Bias Current
Differential Output Offset Voltage
Output Common-Mode Offset
vs Frequency
vs Frequency
vs Frequency
vs Frequency
vs Output Voltage
vs Output Voltage
vs CM Output Voltage
vs CM Output Voltage
vs Frequency
vs Frequency
vs Frequency
vs Frequency
vs Frequency
vs Output Voltage
vs Frequency
vs Frequency
Load Resistance
vs Input Common-Mode Voltage
vs Frequency
vs Frequency
vs Frequency
vs Supply Voltage
vs Frequency
vs Frequency
vs CM Input Voltage
vs CM Input Voltage
vs CM Input Voltage
www.ti.com
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13
Figure 14
Figure 15
Figure 16
Figure 17
Figure 18
Figure 19
Figure 20
Figure 21
Figure 22
Figure 23
Figure 24
Figure 25
Figure 26
Figure 27
Figure 28
Figure 29
Figure 30
Figure 31
Figure 32
Figure 33
Figure 34
Figure 35
Figure 36
Figure 37
6
Submit Documentation Feedback
Product Folder Link(s): THS4511
Copyright © 2005–2009, Texas Instruments Incorporated