MNLMH6624-X Datasheet, PDF (5/12 Pages) National Semiconductor (TI) – ULTRA LOW NOISE WIDEBAND OP AMP

MNLMH6624-X REV 1A0
MICROCIRCUIT DATA SHEET
Electrical Characteristics
DC PARAMETERS: Static and DC Tests
(The following conditions apply to all the following parameters, unless otherwise specified.)
DC: Vs = +5 Vdc, Av = +20, load resistance (Rl = 100 Ohms), feedback resistance (Rf) = 500 Ohms, and gain
setting resistance (Rg) = 26.1 Ohms. -55 C < Ta < +125 C (Note 3).
SYMBOL
Iin
Vio
PARAMETER
Input Bias
Current
Input Offset
Voltage
Is
Supply Current
CONDITIONS
Rl = infinite
PSRR
AOL
Power Supply
Rejection Ratio
Open Loop Gain
+Vs = +4.0V to +5.0V,
-Vs = -4.0V to -5.0V
NOTES
PIN-
NAME
MIN
-20
-0.8
-1
75
77
72
MAX
+20
UNIT
uA
SUB-
GROUPS
1, 2,
3
+0.8 mV 1
+1
mV 2, 3
16
mA 1, 2
18
mA 3
dB 1, 2,
3
dB 4
dB 5, 6
AC PARAMETERS: Frequency Domain Tests
(The following conditions apply to all the following parameters, unless otherwise specified.)
AC: Vs = +5 Vdc, Av = +20, load resistance (Rl = 100 Ohms), feedback resistance (Rf) = 500 Ohms, and gain
setting resistance (Rg) = 26.1 Ohms. -55 C < Ta < +125 C (Note 3).
SSBW
Small Signal
-3 dB bandwidth, Vout < 0.4 Vpp
2
75
Bandwidth
MHz 9
GFP
Gain Flatness
0.1 MHz to 30 MHz, Vout < 0.4 Vpp
2
Peaking Low
0.7
dB 9
GFR
Gain Flatness
0.1 MHz to 30 MHz, Vout < 0.4 Vpp
2
Rolloff
1.0
dB 9
AC PARAMETERS: Distortion and Noise Tests
(The following conditions apply to all the following parameters, unless otherwise specified.)
AC: Vs = +5 Vdc, Av = +20, load resistance (Rl = 100 Ohms), feedback resistance (Rf) = 500 Ohms, and gain
setting resistance (Rg) = 26.1 Ohms. -55 C < Ta < +125 C (Note 3).
HD2
2nd Harmonic
1 Vpp at 10 MHz
Distortion
2
-48
dBc 9
HD3
3rd Harmonic
1 Vpp at 10 MHz
Distortion
2
-65
dBc 9
DC PARAMETERS: DRIFT VALUES
(The following conditions apply to all the following parameters, unless otherwise specified.)
DC: "Deltas not required on B-Level product. Deltas required for S-Level product at Group B5 ONLY, or as
specified on the Internal Processing Instructions (IPI), (Note 3).
Iin
Input Bias
Current
1
-0.2 +0.2 uA 1
Vio
Input Offset
Voltage
1
-0.1 0.1
mV 1
Is
Supply Current
1
-1
+1
mA 1
5