LP124 Datasheet, PDF (4/10 Pages) National Semiconductor (TI) – Micropower Quad Operational Amplifier

Typical Performance Curves (Continued)
Voltage Follower
Pulse Response
Voltage Follower Pulse
Response (Small Signal)
Common Mode
Rejection Ratio
Large Signal
Frequency Response
Output Characteristics
Current Sourcing
TL H 8562 – 20
Output Characteristics
Current Sinking
Current Limiting
Application Hints
The LP124 series is a micro-power pin-for-pin equivalent to
the LM124 op amps Power supply current input bias cur-
rent and input offset current have all been reduced by a
factor of 10 over the LM124 Like its predecessor the
LP124 series op amps can operate on single supply have
true-differential inputs and remain in the linear mode with
an input common-mode voltage of 0 V_DC
The pinouts of the package have been designed to simplify
PC board layouts Inverting inputs are adjacent to outputs
for all of the amplifiers and the outputs have also been
placed at the corners of the package (pins 1 7 8 and 14)
Precautions should be taken to insure that the power supply
for the integrated circuit never becomes reversed in polarity
or the unit is not inadvertently installed backwards in the
TL H 8562 – 19
test socket as an unlimited current surge through the result-
ing forward diode within the IC could destroy the unit
Large differential input voltages can be easily accommodat-
ed and as input differential voltage protection diodes are
not needed no large input currents result from large differ-
ential input voltages The differential input voltage may be
larger than V^a without damaging the device Protection
should be provided to prevent the input voltages from going
negative more than b0 3 V_DC (at 25 C) An input clamp
diode with a resistor to the IC input terminal can be used
The amplifiers have a class B output stage which allows the
amplifiers to both source and sink output currents In appli-
cations where crossover distortion is undesirable a resistor
http www national com
4