LMH6572_05 Datasheet, PDF (4/12 Pages) National Semiconductor (TI) – Triple 2:1 High Speed Video Multiplexer

±3.3V Electrical Characteristics (Continued)
Unless otherwise specified, V_S = ±3.3V, R_L = 100Ω.
Symbol
Parameter
Conditions(Note 2)
Min
Typ
Max
Units
HD3
3^rd Harmonic Distortion
2 V_PP, 10MHz
−74
dBc
IMD
3^rd Order Intermodulation Products 10 MHz, Two tones 2Vpp at output
−79
dBc
Static, DC Performance
GAIN
Voltage Gain
2.0
V/V
VIO
DVIO
Output Offset Voltage
Average Drift
V_IN = 0V
1
mV
36
µV/˚C
IBN
DIBN
Input Bias Current (Note 7)
Average Drift
V_IN = 0V
2
µA
24
nA/˚C
PSRR
Power Supply Rejection Ratio
DC, Input Referred
54
dB
ICC
Supply Current
VIH
Logic High Threshold
R_L = ∞
Select & Enable Pins
20
mA
1.3
V
VIL
Logic Low Threshold
Select & Enable Pins
0.4
V
Miscellaneous Performance
RIN+
Input Resistance
100
kΩ
CIN
Input Capacitance
0.9
pF
ROUT
Output Resistance
0.27
Ω
VO
Output Voltage Range
No load
±2.5
V
VOL
CMIR
Input Voltage Range
R_L = 100Ω
±2.2
V
±1.2
V
IO
Linear Output Current
ISC
Short Circuit Current
V_IN = 0V
V_IN = ±1V, Output shorted to
ground
±60
mA
±150
mA
XTLK
Channel to Channel Crosstalk
5 MHz
−90
dBc
Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for which the device is
intended to be functional, but specific performance is not guaranteed. For guaranteed specifications, see the Electrical Characteristics tables.
Note 2: Electrical Table values apply only for factory testing conditions at the temperature indicated. Factory testing conditions result in very limited self-heating of
the device such that T_J = T_A. No guarantee of parametric performance is indicated in the electrical tables under conditions of internal self heating where T_J > T_A.
See Applications Section for information on temperature de-rating of this device. Min/Max ratings are based on product testing, characterization and simulation.
Individual parameters are tested as noted.
Note 3: The maximum output current (I_OUT) is determined by device power dissipation limitations. See the Power Dissipation section of the Application Section for
more details. A short circuit condition should be limited to 5 seconds or less.
Note 4: Human Body Model 1.5 kΩ in series with 100 pF. Machine Model 0Ω In series with 200 pF
Note 5: Parameters guaranteed by electrical testing at 25˚ C.
Note 6: Parameters guaranteed by design.
Note 7: Positive Value is current into device.
www.national.com
4