DS14C238 Datasheet, PDF (4/5 Pages) National Semiconductor (TI) – Single Supply TIA/EIA-232 4 x 4 Driver/Receiver

Parameter Measurement Information (Continued)
DS011282-7
FIGURE 4. Receiver Propagation Delays and Noise Rejection
Pin Descriptions
V_CC (pin 9) — Power supply pin for the device,
+5V (±10%).
V+ (pin 11) — Positive supply for TIA/EIA-232-E drivers.
Recommended external capacitor: C4 = 1.0 µF (6.3V). This
supply is not intended to be loaded externally.
V− (pin 15) — Negative supply for TIA/EIA-232-E drivers.
Recommended external capacitor: C3 = 1.0 µF (16V). This
supply is not intended to be loaded externally.
C1+, C1− (pins 10 and 12) — External capacitor connection
pins. Recommended capacitor – 1.0 µF (6.3V).
C2+, C2− (pins 13 and 14) — External Capacitor connec-
tion pins. Recommended capacitor – 1.0 µF (16V).
D_IN 1–4 (pins 5, 18, 19, and 21) — Driver input pins are
TTL/CMOS compatible. Inputs of unused drivers may be left
open, an internal pull-up resistor (500 kΩ minimum, typically
5 MΩ) pulls input to V_CC. Output will be LOW for open inputs.
D_OUT 1–4 (pins 2, 1, 24, and 20) — Driver output pins con-
form to TIA/EIA-232-E levels.
R_IN1 1–4 (pins 3, 7, 23, and 16) — Receiver input pins ac-
cept TIA/EIA-232-E input voltages (±15V). Receivers fea-
ture a noise filter and guaranteed hysteresis of 200 mV. Un-
used receiver input pins may be left open. Internal input
resistor (5 kΩ) pulls input LOW, providing a failsafe HIGH
output.
R_OUT 1–4 (pins 4, 6, 22, and 17) — Receiver output pins
are TTL/CMOS compatible. Receiver output HIGH voltage is
specified for both CMOS and TTL load conditions.
GND (pin 8) — Ground Pin.
www.national.com
4