96L02 Datasheet, PDF (4/6 Pages) National Semiconductor (TI) – Dual Retriggerable Resettable Monostable Multivibrator

Operation Notes (Continued)
respond to the trigger If the reset input goes HIGH coinci-
dent with a trigger transition the circuit will respond to the
trigger
96L02 Pulse Width vs R_X and C_X
Input to Pin 4 (12)
Pins 5 (11) and 3 (13) e H
TL F 10203 – 5
6 RESET OPERATION A LOW signal on C_D pin 3 (13)
will terminate an output pulse causing Q to go LOW and
Q to go HIGH As long as C_D is held LOW a delay period
cannot be initiated nor will attempted triggering cause
spikes at the outputs A reset pulse duration in the LOW
state of 25 ns is sufficient to insure resetting If the reset
input goes LOW at the same time that a trigger transition
occurs the reset will dominate and the outputs will not
Typical Characteristics
t_w vs V_CC
t_w(min) vs T_A
FIGURE a
TL F 10203 – 6
t_w vs T_A
TL F 10203 – 7
INPUT PULSE
f j 25 kHz
Amp j 3 0V
Width j 100 ns
t_r e t_f s 10 ns
FIGURE b
4
TL F 10203 – 8