LP2966EP Datasheet, PDF (2/15 Pages) National Semiconductor (TI) – Enhanced Plastic Dual 150mA Ultra Low-Dropout Regulator

Typical Application Circuit
20099330
*SD1 and SD2 must be actively terminated through a pull up resistor. Tie to V_IN if not used.
**ERROR1 and ERROR2 are open drain outputs. These pins must be connected to ground if not used.
# Minimum output capacitance is 1µF to insure stability over full load current range. More capacitance improves superior dynamic performance and provides
additional stability margin.
Block Diagram
www.national.com
20099331
2