DS90C387A_06 Datasheet, PDF (12/19 Pages) National Semiconductor (TI) – Dual Pixel LVDS Display Interface/FPD-Link

DS90C387A Pin Descriptions — FPD Link Transmitter
Pin Name
Rn, Gn, Bn,
DE, HSYNC,
VSYNC
AnP
AnM
CLKIN
R_FB
R_FDE
CLK1P
CLK1M
PD
PLLSEL
PRE
DUAL
V_CC
GND
PLLV_CC
PLLGND
LVDSV_CC
LVDSGND
CLK2P/NC
CLK2M/NC
I/O
No.
Description
I
51
TTL level input. This includes: 16 Red, 16 Green, 16 Blue, and 3 control
lines HSYNC, VSYNC, DE (Data Enable).(Note 10)
O
8
Positive LVDS differential data output.
O
8
Negative LVDS differential data output.
I
1
TTL level clock input.
I
1
Programmable data strobe select. Rising data strobe edge selected when
input is high. (Note 10)
I
1
Programmable control (DE) strobe select. Tied high for data active when DE
is high. (Note 10)
O
1
Positive LVDS differential clock output.
O
1
Negative LVDS differential clock output.
I
1
TTL level input. Assertion (low input) tri-states the outputs, ensuring low
current at power down. (Note 10)
I
1
PLL range select. This pin must be tied to V_CC for auto-range. NC or tied to
Ground is reserved for future use. Typical shift point is between 55 and 68
MHz. (Notes 10, 11)
I
1
Pre-emphasis level select. Pre-emphasis is active when input is tied to V_CC
through external pull-up resistor. Resistor value determines pre-emphasis
level (see table in application section). For normal LVDS drive level (No
pre-emphasis) leave this pin open (do not tie to ground).(Note 10)
I
1
Three-mode select for dual pixel, single pixel, or single pixel input to dual
pixel output operation. Single pixel mode when input is low (only LVDS
channels A0 thru A3 and CLK1 are active) for power savings. Dual mode is
active when input is high. Single in - dual out when input is at 1/2 Vcc. (Note
10)
I
4
Power supply pins for TTL inputs and digital circuitry.
I
6
Ground pins for TTL inputs and digital circuitry.
I
2
Power supply pin for PLL circuitry.
I
3
Ground pins for PLL circuitry.
I
3
Power supply pin for LVDS outputs.
I
4
Ground pins for LVDS outputs.
O
1
Additional positive LVDS differential clock output. Identical to CLK1P. No
connect if not used.
O
1
Additional negative LVDS differential clock output. Identical to CLK1M. No
connect if not used.
Note 10: Inputs default to “low” when left open due to internal pull-down resistor.
Note 11: The PLL range shift point is in the 55 - 68 MHz range, typically the shift will occur during the lock time.
www.national.com
12