LP3881 Datasheet, PDF(1/12 Page) National Semiconductor (TI) – 0.8A Fast-Response Ultra Low Dropout Linear Regulators

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

LP3881 Datasheet, PDF (1/12 Pages) National Semiconductor (TI) – 0.8A Fast-Response Ultra Low Dropout Linear Regulators

June 2006

LP3881

0.8A Fast-Response Ultra Low Dropout Linear

Regulators

General Description

The LP3881 is a high current, fast response regulator which

can maintain output voltage regulation with minimum input to

output voltage drop. Fabricated on a CMOS process, the

device operates from two input voltages: Vbias provides

voltage to drive the gate of the N-MOS power transistor,

while Vin is the input voltage which supplies power to the

load. The use of an external bias rail allows the part to

operate from ultra low Vin voltages. Unlike bipolar regula-

tors, the CMOS architecture consumes extremely low quies-

cent current at any output load current. The use of an

N-MOS power transistor results in wide bandwidth, yet mini-

mum external capacitance is required to maintain loop sta-

bility.

The fast transient response of these devices makes them

suitable for use in powering DSP, Microcontroller Core volt-

ages and Switch Mode Power Supply post regulators. The

parts are available in TO-220, TO-263 and PSOP-8 pack-

ages.

Dropout Voltage: 75 mV (typ) @ 0.8A load current.

Ground Pin Current: 3 mA (typ) at full load.

Shutdown Current: 60 nA (typ) when S/D pin is low.

Precision Output Voltage: 1.5% room temperature accu-

racy.

Features

n Ultra low dropout voltage (75 mV @ 0.8A typ)

n Low ground pin current

n Load regulation of 0.04%/A

n 60 nA typical quiescent current in shutdown

n 1.5% output accuracy (25ËC)

n TO-220, TO-263 and PSOP-8 packages

n Over temperature/over current protection

n â40ËC to +125ËC junction temperature range

Applications

n DSP Power Supplies

n Server Core and I/O Supplies

n PC Add-in-Cards

n Local Regulators in Set-Top Boxes

n Microcontroller Power Supplies

n High Efficiency Power Supplies

n SMPS Post-Regulators

Typical Application Circuit

At least 4.7 ÂµF of input and output capacitance is required for stability.

20063001

www.national.com

▷