DP83640 Datasheet, PDF (1/114 Pages) National Semiconductor (TI) – Precision PHYTER - IEEE 1588 Precision Time Protocol Transceiver

PRELIMINARY
September 2007
DP83640
Precision PHYTER - IEEE 1588 Precision Time Protocol
Transceiver
1.0 General Description
The DP83640 Precision PHYTER® device delivers the high-
est level of precision clock synchronization for real time in-
dustrial connectivity based on the IEEE 1588 standard. The
DP83640 has deterministic, low latency and allows choice of
microcontroller with no hardware customization required. The
integrated 1588 functionality allows system designers the
flexibility and precision of a close to the wire timestamp. The
three key 1588 features supported by the device are:
— Packet time stamps for clock synchronization
— Integrated IEEE 1588 synchronized clock generation
— Synchronized event triggering and time stamping through
GPIO
DP83640 offers innovative diagnostic features unique to Na-
tional Semiconductor, including dynamic monitoring of link
quality during standard operation for fault prediction. These
advanced features allows the system designer to implement
a fault prediction mechanism to detect and warn of deterio-
rating and changing link conditions. This single port fast Eth-
ernet transceiver can support both copper and fiber media.
2.0 Applications
■ ^{Factory Automation}
— Ethernet/IP
— CIP Sync
■ ^{Test and Measurement}
— LXI Standard
■ ^Telecom
— Basestation
■ ^{Real Time Networking}
3.0 Features
■ ^{IEEE 1588 V1 and V2 supported}
■ ^{UDP/IPv4, UPD/IPv6, and Layer2 Ethernet packets}
supported
■ ^{IEEE 1588 clock synchronization}
■ ^{Timestamp resolution of 8 ns}
■ ^{Allows sub 100 ns synchronization to master reference}
■ ^{12 IEEE 1588 GPIOs for trigger or capture}
■ ^{Deterministic, low transmit and receive latency}
■ ^{Selectable frequency synchronized clock output}
■ ^{Dynamic Link Quality monitoring}
■ ^{TDR based Cable Diagnostic and Cable Length Detection}
■ ^{10/100 Mb/s packet BIST (Built in Self Test)}
■ ^{Error-free Operation up to 150 meters}
■ ^{ESD protection - 8 kV human body model}
■ ^{2.5V / 3.3V I/Os and MAC interface}
■ ^{Auto-MDIX for 10/100 Mbps}
■ ^{RMII Rev. 1.2 and MII MAC interface}
■ ^{25MHz MDC and MDIO Serial Management Interface}
■ ^{IEEE 802.3u 100BASE-FX Fiber Interface}
■ ^{IEEE 1149.1 JTAG}
■ ^{Programmable LED support for Link, 10 /100 Mb/s Mode,}
Duplex, Activity, and Collision Detect
■ ^{48 pin LQFP package (7mm) x (7mm)}
4.0 System Diagram
PHYTER^® is a registered trademark of National Semiconductor.
© 2007 National Semiconductor Corporation 300112
30011217
www.national.com