FP0115CAC1BC-C2 Datasheet, PDF (4/5 Pages) Nihon Kaiheiki Industry Co. Ltd. – Contactless Pushbuttons

Contactless Pushbuttons Series FP01
PHOTO INTERRUPTER SPECIFICATIONS
(Temperature @ 25°C)
Electrical & Optical Characteristics
Input
Transmission
Forward Voltage V_F:
Reverse Current I_R:
Collector-Emitter Saturation Voltage V_CE sat:
Typical
1.3V
Maximum
1.6V
10µA
0.4V
Condition
I_F = 50mA
F_R = 5V
I_F = 20mA & I_C = 0.1mA
Absolute Maximum Ratings
Input LED
Forward Current I_F:
Reverse Voltage V_R:
Power Dissipation P_D:
50mA
5V
80mW
Output Photo Transistor
Collector-Emitter Voltage V_CEO:
Emitter-Collector Voltage V_ECO:
Collector Current I_C:
Collector Dissipation P_C:
30V
4.5V
30mA
80mW
Circuit Design Considerations
Output of the infrared LED in the photo
interrupter decreases approximately
50% after 100,000 hours.
Recommended load resistance (RL) is
40k ~ 120kΩ for the illustrated circuit.
VCC = 5V
180Ω
RL
VOUT
Threshold Voltage
VHI: 3.8V
VLO: 1.0V
GND
B _White
ACTUATOR COLORS
C _Red
D _Amber
F _Green
LED COLORS & SPECIFICATIONS
LEDs are an integral
part of the switch and
not available sepa-
rately. The electrical
specifications shown
are determined at a
basic temperature of
25°C.
If the source voltage
exceeds the rated volt-
age, a ballast resistor
is required.
R ₊ I_F
Anode
E
V_F
Cathode
–
R = ^{E – VF}
I_F
Where: R = Resistor Value (Ohms)
E = Source Voltage (V)
V_F = Forward Voltage (V)
I_F = Forward Current (A)
Single Element LED
Forward Peak Current
Continuous Forward Current
Forward Voltage
Reverse Peak Voltage
Current Reduction
Rate Above 25°C
Ambient Temperature Range
C
D
F
Color Red
Amber Green
I_FM
30mA
I_F
20mA
V_F 1.85V
V_RM
5V
∆I_F 0.38mA
/°C
25mA
20mA
2.0V
5V
0.28mA
/°C
25mA
20mA
2.25V
5V
0.40mA
/°C
–25° ~ +50°C
NKK Switches • email: [e-mail] • Phone [phone] • Fax [phone] • www.nkkswitches.com 03-07