FP1 Datasheet, PDF (6/8 Pages) NEC – on-chip resistor PNP silicon epitaxial transistor For mid-speed switching

FP1 SERIES
RECOMMENDED SOLDERING CONDITIONS
This product should be soldered and mounted under the following recommended conditions.
For soldering methods and conditions other than those recommended below, contact an NEC sales representative.
Surface MOUNTING TYPE
For details of the recommended soldering conditions, refer to the document Semiconductor Device Mounting
Technology Manual (C10535E).
6ROGHULQJ 0HWKRG
6ROGHULQJ &RQGLWLRQV
5HFRPPHQGHG
&RQGLWLRQ 6\PERO
,QIUDUHG UHIORZ
3DFNDJH SHDN WHPSHUDWXUH °& 7LPH  VHF PD[ DW °& RU KLJKHU
&RXQW 2QFH ([SRVXUH OLPLW 1RQH
,5
936
3DFNDJH SHDN WHPSHUDWXUH °& 7LPH  VHF PD[ DW °& RU KLJKHU
&RXQW 2QFH ([SRVXUH OLPLW 1RQH
93
3DUWLDO KHDWLQJ
3LQ WHPSHUDWXUH °& PD[ 7LPH  VHF PD[ ([SRVXUH OLPLW 1RQH
2
* After opening the dry pack, store it at 25°C or less and 65% RH or less for the allowable storage period.
Cautions 1. Do not use different soldering methods together (except for partial heating).
2. Prevent the resin surface temperature from being higher than the board temperature by 20°C or
more.
6
Data Sheet D16181EJ1V0DS