UPG2008TB Datasheet, PDF (3/10 Pages) NEC – GaAs INTEGRATED CIRCUIT

µPG2008TB
ELECTRICAL CHARACTERISTICS
(TA = +25°C, Vcont1 = +3 V, Vcont2 = 0 V or Vcont1 = 0 V, Vcont2 = +3 V, ZO = 50 Ω, Off chip DC blocking
capacitors value; 51 pF, unless otherwise specified)
Parameter
Insertion Loss
Isolation
Input Return Loss
Output Return Loss
Input Power at 0.1 dB
Compression Point ^Note
Input Power at 1 dB
Compression Point ^Note
Switching Speed
Control Current
Symbol
Test Conditions
LINS f = 0.5 to 1.0 GHz
f = to 2.0 GHz
f = to 2.5 GHz
ISL f = 0.5 to 2.0 GHz
f = to 2.5 GHz
RLin f = 0.5 to 2.0 GHz
f = to 2.5 GHz
RLout f = 0.5 to 2.0 GHz
f = to 2.5 GHz
Pin(0.1 dB) f = 1.0 GHz, Vcont = +3 V/0 V
Pin(1 dB) f = 1.0 GHz, Vcont = +3 V/0 V
tSW
Icont Vcont = +3 V/0 V, RF Non
MIN.
−
−
−
22
18
13
11
13
11
−
TYP.
0.30
0.40
−
27
−
19
−
19
−
23.0
MAX.
0.55
0.65
0.90
−
−
−
−
−
−
−
Unit
dB
dB
dB
dB
dB
dB
dB
dB
dB
dBm
22.0
26.5
−
dBm
−
50
200
ns
−
0.5
10
µA
Note Pin(0.1 dB) or Pin(1 dB) is measured the input power level when the insertion loss increase more 0.1 dB or 1 dB
than that of linear range. All other characteristics are measured in linear range.
Cautions 1. When the µPG2008TB is used it is necessary to use DC blocking capacitors for No.1 (OUT1),
No.3 (OUT2) and No.5 (IN). The value of DC blocking capacitors should be chosen to
accommodate the frequency of operation, bandwidth, switching speed and the condition with
actual board of your system.
The range of recommended DC blocking capacitor value is less than 100 pF.
2. The distance between IC’s GND pin and ground pattern of substrate should be as shorter as
possible to avoid parasitic parameters.
Data Sheet PG10193EJ01V0DS
3