English
Language : 

UPG138GV Datasheet, PDF (3/8 Pages) NEC – L-BAND SPDT SWITCH
PPG138GV
[PPG138GV]
RECOMMENDED OPERATION CONDITIONS
PARAMETER
Control Voltage (ON)
Control Voltage (OFF)
Input Power (VCONT = ð5 V)
Input Power (VCONT = ð3 V)
SYMBOL
VCONT
VCONT
Pin
Pin
MIN.
ð0.2
ð5.3
TYP.
0
ð3.0
MAX.
+0.2
ð2.7
+35
+33
UNIT
V
V
dBm
dBm
ELECTRICAL CHARACTERISTICS
(UNLESS OTHERWISE SPECIFIED TA = 25 qC, VCONT = ð3 V/0 V, f = 100 MHz to 1 GHz)
CHARACTERISTICS
Insertion Loss 1
Insertion Loss 2
Insertion Loss 3
Isolation 1
Isolation 2
Input Return Loss
Output Return Loss
Input Power at 1 dB
Compression Point
Switching Speed
Control Current
SYMBOL
LINS1
LINS2
LINS3
ISL1
ISL2
RLin
RLout
Pin (1 dB)
Note 2
tSW
ICONT
TEST CONDITION
f = 2.0 GHz
f = 2.5 GHz
f = 2.0 GHz
f = 100 M to 2 GHz
f = 500 M to 2 GHz
f = 500 M to 2 GHz,
VCONT = ð5 V/0 V
VCONT = ð5 V/0 V
MIN.
25
18
11
11
+32
+34
TYP.
0.55
0.65
0.8Note 1
30
20
MAX.
0.75
0.90
+34
+38
UNIT
dB
dB
dB
dB
dB
dB
dB
dBm
dBm
10
ns
5
PA
Notes 1. Characteristic for reference at 2.0 to 2.5 GHz.
2. Pin (1 dB) is measured the input power level when the insertion loss increase more 1 dB than that of
linear range.
All other characteristics are measured in linear range.
NOTE ON CORRECT USE
• Insertion loss and isolation of the IN-OUT2 is better than that of IN-OUT1, because No. 7 pin (OUT1) is placed to
same side of No. 5 pin (IN).
• The distance between IC’s GND pins and ground pattarn of substrate should be as shorter as possible to avoid
parasitic parameters.
3