UPD8873 Datasheet, PDF (27/32 Pages) NEC – (5400 ®5400) PIXELS x 3 COLOR CCD LINEAR IMAGE SENSOR

µ PD8873
RECOMMENDED SOLDERING CONDITIONS
When soldering this product, it is highly recommended to observe the conditions as shown below.
If other soldering processes are used, or if the soldering is performed under different conditions, please make sure
to consult with our sales offices.
Type of Through-hole Device
µ PD8873CY : CCD linear image sensor 22-pin plastic DIP (10.16 mm (400))
Process
Partial heating method
Conditions
Pin temperature : 300 °C or below, Heat time : 3 seconds or less (per pin)
Cautions 1.
2.
During assembly care should be taken to prevent solder or flux from contacting the plastic
cap. The optical characteristics could be degraded by such contact.
Soldering by the solder flow method may have deleterious effects on prevention of plastic
cap soiling and heat resistance. So the method cannot be guaranteed.
Data Sheet S16614EJ2V0DS
27