UPG152TA Datasheet, PDF (2/12 Pages) NEC – L-BAND SPDT SWITCH

P_PG152TA
PIN CONNECTION DIAGRAM
PIN No.
1
2
3
CONNECTION
OUT1
GND
OUT2
PIN No.
4
5
6
CONNECTION
VCONT 2
IN
VCONT 1
(Top View)
3
4
2
5
1
6
(Bottom View)
4
3
5
2
6
1
RECOMMENDED OPERATING CONDITIONS (TA = 25 °C)
PARAMETERS
Control Voltage (OFF)
Control Voltage (ON)
Input Power (VCONT = 3 V/0 V)
SYMBOL
VCONT
VCONT
Pin
MIN.
+2.7
ð0.2
TYP.
+3.0
0
+27
MAX.
+5.3
+0.2
+29
UNIT
V
V
dBm
ELECTRICAL CHARACTERISTICS (Unless otherwise specified, TA = 25 °C, VCONT1 = 3 V,
VCONT2 = 0 V or VCONT1 = 0 V, VCONT2 = 3 V, Off chip DC blocking capacitors value; 51 pF)
CHARACTERISTICS
Insertion Loss
Isolation
Input Return Loss
Output Return Loss
Input Power at 1 dB
Compression Point^{Note 2}
Switching Speed
Control Current
SYMBOL
LINS
ISL
RIin
RIout
Pin(1 dB)
TEST CONDITIONS
f = 100 M to 2 GHz
f = 2.5 GHz
f = 100 M to 2 GHz
f = 2.5 GHz
f = 100 M to 2 GHz
f = 100 M to 2 GHz
f = 1 GHz to 2 GHz
tsw
ICONT
VCONT = 3 V/0 V RF None
MIN. TYP.
0.6
0.8^{Note 1}
20
22
20 ^{Note 1}
11
11
27
30
MAX.
1.0
UNIT
dB
dB
dB
dB
dBm
30
ns
5
PA
Notes 1 Characteristic for reference at 2.0 to 2.5 GHz
2 Pin(1 dB) is measured the input power level when the insertion loss increase more 1 dB than that of
linear range. All other characteristics are measured in linear range.
3 When the PPG152TA is used it is necessary to use DC blocking capacitors for No.1 (OUT1), No.3
(OUT2) and No.5 (IN). The value of DC blocking capacitors should be chosen to accommodate the
frequency of operation, band width, switching speed and the condition with actual board of your system.
The range of recommended DC blocking capacitor value is less than 100 pF.
4 The distance between IC’s GND pin and ground pattern of substrate should be as shorter as possible to
avoid parasitic parameters.
2