|
SP2-DC3V Datasheet, PDF (6/6 Pages) Nais(Matsushita Electric Works) – 15A (2C), 10A (4C) COMPACT POWER RELAYS WITH HIGH SENSITIVITY | |||
|
◁ |
Use method
1. Both the SP relay 2c and 4c can be
mounted to the mounting slats.
2. Use the mounting slats either by attach-
ing them directly to the chassis, or by
mounting with a DIN rail.
(A) When attaching directly to chassis
Use two M3 screws.
For the mounting pitch, refer to the speci-
ï¬cation diagram.
(B) When mounting on a DIN rail
Use a 35mm 1.378inch wide DIN rail
(DIN46277).
The mounting method should be as indi-
cated in the diagram at right.
Method for mounting on DIN rail
Press
Fit in
Fig. 1
Mounting
slat
DIN rail
Press relay in
Fig. 2
Fit into mounting
grooves.
Fig. 3
To remove the
relay, press down
the mounting slats
so the claws move
to the outside.
SP
(1) First ï¬t the arc shaped claw of the
mounting slat into the DIN rail.
(2) Press on the side as shown in the dia-
gram below.
(3) Fit in the claw part on the opposite
side.
Precautions for use
When mounting to a DIN rail, use a com-
mercially available fastening bracket if
there is a need to stop sliding of the
mounting slat in the rail direction.
For Cautions for Use, see Relay Technical Information (Page 48 to 76).
9/1/2000
All Rights Reserved, © Copyright Matsushita Electric Works,2L5td7.
Go To Online Catalog
|