RGLD8X103J Datasheet, PDF (3/19 Pages) Murata Manufacturing Co., Ltd. – SIP Resistor Network

Please read CAUTION and Notice in this catalog for safety. This catalog has only typical specifications. Therefore you are requested
to approve our product specification or to transact the approval sheet for product specification, before your ordering.
N16E9.pdf 01.11.26
( ) o Part Numbering
The structure of the "Global Part Numbers" that have been adopted since June 2001 and the meaning of each code are described herein.
If you have any questions about details, inquire at your usual Murata sales office or distributor.
R Network
(Global Part Number)
X, Y, L Circuit RG LD 8 X 103 J
T2
q w er t y
o
Z, M Circuit
RG LD 8 M 103 J 104 J T2
q w er t y u i o
Custom Circuit RG LD 8 A
q w er
qProduct ID
Product ID
RG
R Networks
1234
!0
wStructure
Code
LD
LE
SD
HD
Structure
Terminal Pitch : 2.54mm, Height : 5.0mm max.
Terminal Pitch : 1.78mm, Height : 5.0mm max.
Terminal Pitch : 2.54mm, Height : 6.5mm max.
Terminal Pitch : 2.54mm, Height : 9.0mm max.
eNumber of Element
Code
8
Number of Element
1 or 2 digits shows the number of element.
rCircuit
Code
X
Y
Z
M
L
A
Circuit
Pull-up, Pull-down Circuit
Isolated Circuit
Double Terminator Circuit
Divider Circuit
R/2R Ladder Circuit
Custom Circuit
( ) tNominal Resistance Z, M Circuit : RA
L Circuit : Output Impedance
Expressed by three figures. The unit is ohm (Ω). The first and
second figures are significant digits, and the third figure
expresses the number of zeros which follow the two figures.
Ex.)
Code
150
103
Nominal Resistance
15Ω
10kΩ
( ) yResistance Tolerance Z, M Circuit : RA
L Circuit : Impedance Tolerance
Code
J
G
Resistance Tolerance
±5%
±2%(22Ω min.)
uNominal Resistance (Z, M Circuit : RB)
Expressed by three figures. The unit is ohm (Ω). The first and
second figures are significant digits, and the third figure
expresses the number of zeros which follow the two figures.
Ex.)
Code
Nominal Resistance
150
15Ω
104
100kΩ
If RA and RB values are the same, u and i remain blanks, and
the corresponding code is omitted.
iResistance Tolerance (Z, M Circuit : RB)
Code
Resistance Tolerance
J
±5%
G
±2%(22Ω min.)
oPackaging
Code
T1
T2
Packaging
All-Pin Taping
3pins Taping
!0Design No.
Code
1234
Design No.
Expressed by four figures
2