MVAD160-12 Datasheet, PDF (3/6 Pages) Murata Manufacturing Co., Ltd. – 160W 2" X 4" AC-DC Power Supply Converter

MVAD160 Series
160W 2" X 4" AC-DC Power Supply Converter
CONTROL SIGNAL
Parameter
V1 Remote
Conditions
This signal must be pulled low state (maximum of 0.2Vdc, sink current >15mA) to V2 return terminal to turn on the main V1
output. The power supply shall include an internal pull up resistor to an internal 12Vdc to disable the main V1 output if the
signal is left open. The power supply shall not pull this signal down if there is no AC input. The open circuit voltage present
when in the “open” state shall not exceed 15Vdc.
The AUX output is independent of the V1 remote signal.
EMI CONSIDERATIONS
For optimum EMI performance, the power supply should be mounted to a metal plate grounded to all 4 mounting holes of the power supply. To comply with
safety standards, this plate must be properly grounded to protective earth (see mechanical dimension notes). Pre-compliance testing has shown that a stand-
alone power supply complies with EN55022 class A radiated emissions. Radiated emission results vary with system enclosure and cable routing paths.
SAFETY CONSIDERATIONS
1. This power supply is a component level power supply intended for use in Class I or Class II applications. Secondary ground traces need to be suit-
ably isolated from primary ground traces when used in class II applications.
2. When the power supply is used in Class II equipment, all ground traces and components connected to the primary side are considered primary for
spacing and insulation considerations.
PERFORMANCE DATA
Efficiency plot for MVAD160-12
94
Efficiency plot for MVAD160-24
94
92
92
90
90
88
86
Vin=115V
84
Vin=230V
82
80
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Io (A)
88
86
Vin=115V
84
Vin=230V
82
80
0.0 1.0 2.0 3.0 4.0 5.0 6.0 7.0
Io (A)
94
Efficiency plot for MVAD160-48
Inrush waveform (AC264V 25°C) Peak 84.0A
92
90
88
86
Vin=115V
84
Vin=230V
82
80
0.0 0.5 1.0 1.5 2.0 2.5 3.0 3.5
Io (A)
hptotwp:e/r/.pmouwreart.am.cuormata.com
MVAD160.A04 Page 3 of 6