LQH2HP_G0 Datasheet, PDF (2/2 Pages) Murata Manufacturing Co., Ltd. – Chip Inductor Power Inductor

Inductors (Coils) > Chip Inductor (Chip Coil) > Power Inductor (Wire Wound Type)
Data Sheet
2
Continued from the preceding page.
c Inductance-Frequency Characteristics (Typ.)
1000
c Inductance-Current Characteristics (Typ.)
1000
100μH
100
22μH
10μH
6.8μH
10
4.7μH
3.3μH
2.2μH
1
100
100μH
10μH
6.8μH
22μH
4.7μH
10
3.3μH
2.2μH
1
0.1
0.1
1
10
100
Frequency (MHz)
1000
0.1
10
100
1000
Current (mA)
10000
c Temperature Rise Characteristics (Typ.)
50
100μH
40
30
10μH
22μH
6.8μH
4.7μH _3.3μH
2.2μH
20
10
0
0
350
700
1050
1400
Current (mA)
c !Caution/Notice
!Caution (Rating)
Do not use products beyond the rated current as
this may create excessive heat.
Notice
Solderability of Tin plating termination chip might be
deteriorated when low temperature soldering profile
where peak solder temperature is below the Tin melting
point is used. Please confirm the solderability of Tin
plating termination chip before use.
oThis data sheet is applied for CHIP INDUCTORS (CHIP COILS) used for General Electronics equipment for your design.
!Note:
1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it
may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering.
2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product
specifications or transact the approval sheet for product specifications before ordering.
2012.5.10
http://www.murata.com/