JECXDE-0015 Datasheet, PDF (14/16 Pages) Murata Manufacturing Co., Ltd. – Electrical Double Layer Capacitor

Specification of Electrical Double Layer Capacitor
(3)Hand Soldering
Please solder under following conditions.
Soldering iron temperature at 350 deg C +/-10 deg C
Solder Iron wattage: 70W or less
Soldering time: Within 5 sec per one terminal
Allowable soldering frequencies: 3 times /device.
* Please allow at least for 15 sec between successive soldering per one terminal.
Please do not touch laminate package directly by solder iron.
In order to ensure the connectivity, please apply preparatory solder on the land.
When soldering, please apply flux or flux solder, heating the preparatory solder.
(4) Please refer to figure below for designing land pattern.
Balance Terminal
a
a
a
Land pattern
b
Negative(-)Terminal
c
Product
Positive(+) Terminal
Package
c
a_a=₌2₂._.2₅m_mm_m
b_b=₌3₃._.0₀m_~4m_.0mm
c_c=₌1₁._.3₀m_mm
Land pattern and Product package
(5) Please do not wash the device after soldering.
11.5. Disassembly
This device uses a volatile organic electrolyte. Please do not disassemble it.
11.6. Disposal
This device should be disposed of as industrial waste in accordance with local laws and
regulations. Never throw this device into fire.
11.7. Response to IATA Dangerous Goods Regulations
According to 54th Edition of IATA Dangerous Goods Regulations effective from January 1,
2013, Electrical Double Layer Capacitor (ELDC) with an energy storage capacity greater than
0.3 Wh is treated as dangerous goods and introduced as UN3499 in Class 9.
However, an energy storage capacity of each Murata’s EDLCs is not greater than 0.3 Wh.
Therefore, Murata’s EDLCs are not covered by this regulation.
Murata Manufacturing Co., Ltd.
14