MB1000ERW Datasheet, PDF (1/4 Pages) MicroPower Direct, LLC – MB1000ERW

MB1000ERW
Low Cost, 1 x 2 Inch
10W, 2:1 Input Range
DC/DC Converters
Electrical Specifications
Key Features:
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
• 10W Output Power
• 2:1 Input Voltage Range
Parameter
Input Voltage Range
Conditions
Min. Typ. Max.
12 VDC Input 9.0 12.0 18.0
24 VDC Input 18.0 24.0 36.0
Units
VDC
• 1,500 VDC Isolation
48 VDC Input 36.0 48.0 75.0
• Single & Dual Outputs
• Efficiency to 90%
Input Start Voltage
12 VDC Input
24 VDC Input
48 VDC Input
9.0
18.0
VDC
36.0
• Compact 1 x 2 Inch Case ^{Input Filter}
Output
• -40°C to +85°C Operation _Parameter
Conditions
␲ (Pi) Filter
Min. Typ. Max.
Units
• Industry Standard Pin-Out ^{Output Voltage Accuracy}
• Low Cost
Output Voltage Balance
Line Regulation
Dual Outputs, Balanced Loads
VIN = Min to Max
±1.0 ±2.0
%
±0.5 ±1.5
%
±0.2 ±0.5
%
Load Regulation
IOUT = 5% to 100%
±0.5 ±1.0
%
Cross Regulation
See Note 1
±5.0
%
Ripple (20 MHz)
Noise (20 MHz)
See Note 2
15
40
35
80
mV P - P
Transient Recovery Time, See Note 3
Transient Response Deviation
25% Load Step Change
300 500
±3.0 ±5.0
µSec
%
Temperature Coefficient
±0.03 %/°C
Over Voltage Protection
110 120 140
%
Output Short Circuit, See Note 4
Continuous (Autorecovery)
General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,500
VDC
Isolation Resistance
500 VDC 1,000
M
Isolation Capacitance
100 kHz, 0.1V
1,000
pF
Switching Frequency
350
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +85
°C
Operating Temperature Range
Case
+105
°C
Storage Temperature Range
-55
+125
°C
Cooling
Free Air Convection
Humidity
RH, Non-condensing
95
%
Physical
Case Size
2.0 x 1.0 x 0.465 Inches (50.8 x 25.4 x 11.8 mm)
Case Material
Aluminum Alloy With Non-Conductive Base (UL94-V0)
Weight
0.78 Oz (22g)
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Remote On/Off
Parameter
Unit On
Unit Off
Off Idle Current
Reliability Specifications
Conditions
Min. Typ. Max.
See Note 5 3.5
12.0
See Note 5 0
1.2
1.0 3.0
Units
VDC
VDC
mA
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Parameter
MTBF
Absolute Maximum Ratings
Parameter
Conditions
Min. Typ. Max.
MIL HDBK 217F, 25°C, Gnd Benign 1.0
Conditions
Min. Typ. Max.
12 VDC Input -0.7
25.0
Units
MHours
Units
Input Voltage Surge (1 Sec)
24 VDC Input -0.7
50.0
VDC
48 VDC Input -0.7
100.0
Lead Temperature
1.5 mm From Case for 10 Sec
300
°C
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com