IG120 Datasheet, PDF (1/4 Pages) MicroPower Direct, LLC – IG120 SERIES

IG120 ^Series
High Isolation
IGBT Driver
DC/DC Converters
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Key Features:
Input
• Operates With xx962 Drivers ^Parameter
• Independent Outputs
Supply Voltage Range
• EN 60950 Approved
Input Filter
• 3,000 VAC Isolation
Output
• Miniature SIP Case
Parameter
• >3.5 MHour MTBF
Line Regulation
• Seven Standard Models ^{Load Regulation}
• LOW COST!!
Ripple & Noise (20 MHz)
Efficiency
Conditions
Min. Typ.
See Model Selection Guide
Internal Capacitor
Max.
Units
Conditions
For VIN Change of 1%
See Note 1
Min.
Typ.
±1.2
6.3
100
80
Max.
±1.5
15
200
Units
%
%
mV P - P
%
Temperature Coefficient
±0.03 %/ºC
Output Short Circuit
Continuous (Autorecovery)
General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 3,000
VAC
Isolation Resistance
1,000
M⍀
Isolation Capacitance, 1 kHz/0.1V
6.6
pF
Switching Frequency
100 300
kHz
EMI Characteristics
Parameter
Standard
Level
Radiated Emissions
See Page 3
EN 55022
Class B
Conducted Emissions
See Page 3
EN 55022
Class B
ESD
EN 61000-4-2
Criteria B; ±8 kV Contact
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +105
ºC
Storage Temperature Range
-50
+125
ºC
Cooling
Free Air Convection
Humidity
RH, Non-condensing
95
%
Physical
Case Size
0.768 x 0.386 x 0.492 Inches (19.50 x 9.80 x 12.50 mm)
Case Material
Non-Conductive Black Plastic (UL94-V0)
Weight
0.152 Oz (4.3g)
Reliability Specifications
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Parameter
MTBF
Absolute Maximum Ratings
Parameter
Conditions
Min. Typ. Max.
MIL HDBK 217F, 25ºC, Gnd Benign 3.5
Units
MHours
Conditions
Min. Typ. Max.
IG120-12 -0.7
13
Units
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Max Supply Voltage (1 Sec)
IG120-12W -0.7
IG100-9, IG100-9D -0.7
IG120-15, IG136-15 -0.7
IG120-24 -0.7
15
16
VDC
16
26
Lead Temperature
1.5 mm From Case For 10 Sec
300
ºC
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com