H100E Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – Low Cost, 1W, Ultra-Miniature DC/DC Converters

H100E _Series
Low Cost, 1W,
Ultra-Miniature
DC/DC Converters
Electrical Specifications
Key Features:
• 1W Output Power
• Miniature MiniDIP Case
• UL Approved (File E245422)
• 1,000 VDC Isolation
• >3.5 MHour MTBF
• 17 Standard Models
• Industry Standard Pin-Out
• LOWEST COST!
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
3.3 VDC Input 3.0 3.3 3.6
Input Voltage Range
5 VDC Input 4.5 5.0 5.5
12 VDC Input 10.8 12.0 13.2
VDC
24 VDC Input 21.6 24.0 26.4
Input Filter
Internal Capacitor
Reverse Polarity Input Current
0.3
A
Output
Parameter
Conditions
Min. Typ. Max. Units
Output Voltage Accuracy
±1.0 ±3.0
%
Line Regulation, 3.3V Output Models
Line Regulation, All Other Models
For Vin Change of 1%
±1.5
%
±1.2
Load Regulation
See Model Selection Guide
Ripple & Noise (20 MHz)
75 100 mV P - P
Output Power Protection
120
%
Temperature Coefficient
±0.03 %/ºC
Output Short Circuit
Momentary (1.0 Sec.)
General
Parameter
Conditions
Min. Typ. Max. Units
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Isolation Voltage
Isolation Resistance
Isolation Capacitance
Switching Frequency
Environmental
Parameter
Operating Temperature Range
Storage Temperature Range
Cooling
Humidity
Physical
Case Size, Single Output Models
Case Material
Weight
Reliability Specifications
Parameter
MTBF
Safety Standards
Safety Approvals
Absolute Maximum Ratings
Parameter
Input Voltage Surge (1 Sec)
60 Seconds 1,000
500 VDC 1,000
100 kHz, 1V
60 100
100
VDC
MΩ
pF
kHz
Conditions
Min. Typ.
Ambient -40 +25
-55
Free Air Convection
RH, Non-condensing
Max.
+85
+125
95
Units
ºC
ºC
%
0.50 x 0.393 x 0.30 Inches (12.70 x 10.00 x 7.70 mm)
Non-Conductive Black Plastic (UL94-V0)
0.06 Oz (1.8g)
Conditions
MIL HDBK 217F, 25ºC, Gnd Benign
Not 3.3 Vout Models
Min. Typ. Max. Units
3.5
MHours
UL 1950, EN 60950, IEC 60950
UL, cUL; File No. E245422
Conditions
Min. Typ. Max.
3.3 VDC Input -0.7
7.0
5 VDC Input -0.7
9.0
12 VDC Input -0.7
18.0
Units
VDC
24 VDC Input -0.7
30.0
Lead Temperature
1.5 mm From Case For 10 Sec
300
ºC
Internal Power Dissipation
All Models
450
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.