DRM33395 Datasheet, PDF (24/44 Pages) Motorola, Inc – ANALOG ICs 33395 EVALUATION MOTOR BOARD DESIGNER REFERENCE MANUALv

Pin Descriptions
Freescale Semiconductor, Inc.
3.3.3 Output Connectors: J2, J4, FASTONS (J5, J7, J8)
Power output to the motor is located on connectors J2, J4 and
FASTONS (J5, J7, J8). Pin assignments are described in Table 3-2.
FASTON type connectors are labelled with PhA (connector J8) for phase
A, PhB (J7) for phase B, and PhC (J5) for phase C. Phase order is
identical for all three connectors. Note that wire color may vary with
different motor types.
Table 3-2 Connectors J2 and J4 Signal Descriptions
Pin Signal FASTON
No. Name Pin Name
Description
1 Phase_A
J8
Phase_A supplies power to motor phase A.
2 Phase_B
J7
Phase_B supplies power to motor phase B.
3 Phase_C
J5
Phase_C supplies power to motor phase C.
3.3.4 Jumpers and Switch/Push Button: M0, M1, PWM, SW1
The jumper groups M0 (JP2) and M1 (JP3) are used to select the
operating mode of the SMOS gate driver (see Table 3-3). For the truth
table of the driver, see its data sheet.
Table 3-3 Driver Jumper Groups for Operating Mode
MO (JP2)
+ position
- position
M1 (JP3)
+ position
- position
Comment
High state logic 1
Low state logic 0 (default)
For selection of the PWM signal brought to the gate driver, the 140A01
board version uses the SW1 rotary switch and the 140A02 version uses
the PWM (JP5) jumper group and RESET (SW1) push button. Both
solutions have the same behavior (see Table 3-4 for an explanation).
When one PWM signal is sent from the controller board to the motor
board through the UNI-3 interface, the SMOS driver must multiplex it
between the three phases according to the mode defined by M0 and M1.
The mode selection is not needed when six PWM signals are generated.
DRM33395 Designer Reference Manual
33395 Evaluation Motor Board
22
Pin Descriptions
MOTOROLA
For More Information On This Product,
Go to: www.freescale.com