MC33389 Datasheet, PDF (1/35 Pages) Motorola, Inc – System Basis Chip with Low Speed Fault Tolerant CAN

MOTOROLA ^{Order Number: MC33389/D}
Semiconductor Technic^Fa^rl ^eD^ea^sta^{cale Semiconductor, Inc.}
Rev 3.5, March 17th, 03
Advance Information
System Basis Chip with Low
Speed Fault Tolerant CAN
MC33389
AUTOMOTIVE SBC
SYSTEM BASIS CHIP
The MC33389 is a monolithic integrated circuit combining many functions
frequently used by automotive ECUs. It incorporates a low speed fault tolerant
CAN transceiver.
SILICON MONOLITHIC
INTEGRATED CIRCUIT
• Dual Low Drop Voltage Regulators, with Respectively 100mA and 200mA
Current Capabilities, Current Limitation and Over Temperature Detection with
Prewarning
• 5V Output Voltage for V1 Regulator
• Three Operational Modes (Normal, Standby and Sleep Mode) Separated
from the CAN Interface Operating Modes
• Low Speed 125kBaud Fault Tolerant CAN Interface, Compatible with
MC33388 Standalone Physical Interface
• V1 Regulator Monitoring and Reset Function
• Three External High Voltage Wake-up Inputs, Associated with V3 V_bat Switch
• 100mA Output Current Capability for V3 V_bat Switch Allowing Drive of
External Switches or Relays
• Low Standby and Sleep Current Consumption
• V_bat Monitoring and V_bat Failure Detection Capabilities
• DC Operating Voltage up to 27V
• 40V Maximum Transient Voltage
• Programmable Software Window Watchog and Reset
• Wake up Capabilities (CAN Interface, Local Programmable Cyclic Wake up)
• Interface with MCU through SPI
• Programmable Interupt Function
Simplified Block Diagram
VBAT
(+12V)
Dual Voltage Regulator
Voltage control _5V
Bat fail detect
VCC monitor _5V
VBAT switch supply
Mode control
V2
max 200mA
max 110mA
V1
PIN CONNECTIONS
DH SUFFIX
POWER PACKAGE
CASE 979C
HSOP-20
TX 1
V1 2
RX 3
RSTB 4
INTB 5
MISO 6
MOSI 7
SCK 8
CSB 9
L2 10
TX 1
V1 ²
RX ³
RSTB 4
INTB 5
GND ⁶
GND 7
GND 8
GND 9
MISO 10
MOSI 11
SCK 12
CSB 13
L2 14
20 V3
19 VBAT
18 _RTL
17 _V2
16 _CANH
15 GND
14 _CANL
13 _RTH
12 _L0
11 _L1
DW SUFFIX
PLASTIC PACKAGE
CASE 751F
SO-28
28 V3
27 VBAT
26 RTL
25 V2
24 CANH
23 GND
2 2 GND
2 1 GND
20 GND
19 CANL
18 RTH
17 NC
16 L0
15 L1
I3 max. 100mA
V3
(Switch supply)
Interrupt control
Reset control
Watchdog & oscillator
INT
Reset
ORDERING INFORMATION
Device and version
Operating
Temperature Range ^Package
MC33389ADW (1) T_A = -40 to 125°C SO-28
SPI Interface
MOSI
SCK
MISO
CSB
MC33389ADH (1) T_A = -40 to 125°C HSOP20
MC33389CDW (2) T_A = -40 to 125°C SO-28
MC33389CDH (2) T_A = -40 to 125°C HSOP20
MC33389DDW (3) T_A = -40 to 125°C SO-28
L0
Wake-up _L1
inputs
L2
Programmable
wake-up inputs
Gnd
(1) Version A: If device remains in reset greater than 100ms due
to V1 undervoltage, device switches to sleep mode to minimise
current consumption. Wake-up configuration active.
CAN H
R1 _Rth
R2 ^Rtl
CAN L
Fault tolerant
CAN
transceiver
(2) Version C: In V1 undervoltage condition, device remains in
permanent reset state until V1 returns to nominal conditions. V1
protected by overcurrent and over temperature functions.
TX
(3) Version D: In V1 undervoltage condition, device remains in
RX
permanent reset state until V1 returns to nominal conditions. V1
protected by overcurrent and over temperature functions.
Change of undervoltage reset threshold. Refer to electrical pa-
rameter table, V1 PIn 5V.
For More Information On This Product,
This document contains information on a new product under de_Gve_olop_tm_oen_:t._wMo_wtor_wola_.r_fe_rs_eer_eve_ss _cthe_ale.com
right to change or discontinue this product without notice.
© Motorola, Inc., 2002. All rights reserved.