URF1D12HB-150W Datasheet, PDF (5/8 Pages) MORNSUN Science& Technology Ltd. – Wide input voltage range

DC/DC Converter
URF1D_HB-150W Series
Design Reference
1. Ripple & noise
All the URF1D_QB-100W series have been tested according to the following recommended test circuit before leaving the factory (see
Fig. 2)，Ripple & noise tested according to Fig. 3
Copp er sh eet
DC
Inp ut
C0
+V in
Ct rl
100 uF Ca se
- Vin
+Vo
sense +
Trim 2 .54 mm
sense -
0V
C1 C2
1u F _{10u F}
Load
Con nect
Osci llogr aph Probe
(20MH z ba ndwidth )
2 5.4 m m
5 1m m
Fig. 2
Fig. 3
Note: Capacitive value C1:1µF/50V; C2:10µF/35V.
2. Typical application
If not using our Mornsun’s EMC recommended circuit, please ensure an 100μF electrolytic capacitors in parallel with the input, which
used to suppress the surge voltage come from the input terminal.
If it is required to further reduce input and output ripple, properly increase the input & output of additional capacitors Cin and Cout or
select capacitors of low equivalent impedance provided that the capacitance is no larger than the max. capacitive load of the
product.
+Vin
+Vo
Cin
DC DC Cout
-Vin
0V
Capacitive
Parameter
Output Voltage
12V、15V、24V
Cout(µF)
220
Cin(µF)
100
3. EMC solution-module recommended circuit
CY1
+Vin
FU SE
++
-Vin
MOV1 C0 C1
LDM 1
L C M1
C3 C4 C5
+Vin +Vo
+ _DC/DC + _LOAD
-Vin
C6 C7 C2
0V _C8
CY2
Fig. 4
2016.01.31-A/1
Page 5 of 8
MORNSUN Guangzhou Science & Technology Co., Ltd. reserves the copyright and right of final interpretation