D030505M-1W Datasheet, PDF (3/3 Pages) MORNSUN Science& Technology Ltd. – TWIN OUTPUT DC-DC CONVERTER

OUTLINE DIMENSIONS & PIN CONNECTIONS
MECHANICAL DIMENSIONS
16.50 [0.650]
6.00 [0.236]
(Bottom View)
1 2 34 56
0.90 [0.035]
2.54 [0.100]
12.70 [0.500]
RECOMMENDED FOOTPRINT
12.70 [0.500]
∅1.00 [∅0.039]
1 23 4 56
7.50 [0.295]
(Side View)
0.50 [0.020]
4.10 [0.161]
0.50 [0.020]
Note:
Uni t:m m [i nch]
P i n section tolerances: ±0.10m m[0.004i nch]
General tol erances: ±0.25m m [ ±0.010i nch]
F OOTPRINT DETAILS
Pi n
Function
1
Vi n
2
GND
3
0V1
4
Vo1
5
0V2
6
Vo2
2.54 [0.100]
TUBE OUTLINE DIMENSIONS
9.40 [0.370]
16.70 [0.657]
12.20 [0.480]
0.60 [0.024]
4.70 [0.185]
Note:
Unit :mm[inch]
General tolerances: ±0.50mm[±0.020inch]
L=530mm[20.866inch] Tube Quantity: 30pcs
L=220mm[8.661inch] Tube Quantity: 11pcs
Note:
1. Operation under minimum load will not damage the converter; However, they may not meet all specification listed.
2. All specifications measured at Ta=25°C, humidity<75%, nominal input voltage and rated output load unless otherwise specified.
3. In this datasheet, all the test methods of indications are based on corporate standards.
4. Only typical models listed, other models may be different, please contact our technical person for more details.
The copyright and authority for the interpretation of the products are reserved by Mornsun
Specifications subject to change without notice.
D_M-1W
A/0-2009
Page 3 of 3