63811-2600 Datasheet, PDF (3/5 Pages) Molex Electronics Ltd. – Hand Crimp Tool Specification Sheet

Hand Crimp Tool for MX150 Blade Crimp Terminals
Terminal Series No.
33000
33011
31296
Wire Size
AWG mm²
18 0.83
20 0.58
22 0.36
18 0.83
20 0.58
22 0.36
18 0.83
20 0.58
22 0.36
Insulation Crimp
Height
Width
mm
In.
mm
In.
1.90-2.10 .075-.083 2.20-2.40 .087-.094
1.80-2.00 .071-.079 2.00-2.20 .079-.087
1.75-1.95 .069-.077 1.80-2.00 .071-.079
1.90-2.10 .075-.083 2.20-2.40 .087-.094
1.80-2.00 .071-.079 2.00-2.20 .079-.087
1.75-1.95 .069-.077 1.80-2.00 .071-.079
1.90-2.10 .075-.083 2.20-2.40 .087-.094
1.80-2.00 .071-.079 2.00-2.20 .079-.087
1.75-1.95 .069-.077 1.80-2.00 .071-.079
Pull Force
Minimum
N Lb.
90.0 20.25
75.0 17.00
50.0 11.25
90.0 20.25
75.0 17.00
50.0 11.25
90.0 20.25
75.0 17.00
50.0 11.25
OPERATION
Open the tool by squeezing the handles together, at the end of the
closing stroke, the ratchet mechanism will release the handles, and
the hand tool will spring open.
WIRE STOP
BLADES
Crimping Terminals
1. Lift the wire stop blades up.
2. Insert the terminal fully into the correct die profile and the locator
slot until the terminal is fully seated and stops.
3. Bring down the wire stop blades. Make sure the wire stop
LOCATOR
blades are fully seated on the terminal behind the conductor grip
section.
4. Slide the pre-stripped wire into the terminal; make sure to
aim the wire brush towards the tip point on the wire stop WIRE STOP
blade. See Figure 1. Align the wire so that it is parallel
BLADES
and sitting into the terminal. Maintain a light and constant
pressure on the wire that is seated in the terminal at all
times. (Do not let go of the wire.) Be sure to hold the
RETAINER
wire and terminal in place until the terminal is fully
crimped. See Figure 2.
5. Close the tool until the ratchet releases.
LOCATOR
6. Lift the wire stop blades up.
7. Carefully remove the crimped terminal.
PRE-STRIPPED
TERMINAL
WIRE
Figure 1
SPACER
CONDUCTOR
PUNCH
INSULATION
PUNCH
Figure 2
Note: To maintain a good brush control and a consistent bell
mouth the crimping instructions must be followed.
TERMINAL
CONDUCTOR ANVIL
WIRE
INSULATION
ANVIL
Doc No: ATS-638112600 Release Date: 01-21-03
Revision: E
Revision Date: 08-31-09
UNCONTROLLED COPY
Page 3 of 5