63811-2400 Datasheet, PDF (2/5 Pages) Molex Electronics Ltd. – Hand Crimp Tool Specification Sheet

Hand Crimp Tool for 1.50mm (.591") Pitch, MX150 Blade Crimp Terminals
CONDITIONS:
After crimping, the crimp profiles should measure the following (see notes on page 4).
Terminal
Series No.
33000
33011
Bell mouth
Conductor Brush Bend up Bend Down
mm
In.
mm
In.
Degree
0.25-1.25 .010-.049 0.15-0.65 .006-.026
3
3
0.25-1.25 .010-.049 0.15-0.65 .006-.026
3
3
Wire brush must be flush or below top of Conductor Crimp.
Twist Roll
Degree
3
5
3
5
Terminal Series No.
33000
33011
Wire Size
AWG mm²
14 2.00
16 1.27
14 2.00
16 1.27
Conductor Crimp
Height
Width
mm
In.
mm
In.
1.60-1.70 .063-.067 2.35-2.55 .093-.100
1.30-1.40 .051-.055 2.05-2.25 .081-.089
1.60-1.70 .063-.067 2.35-2.55 .093-.100
1.30-1.40 .051-.055 2.05-2.25 .081-.089
Profile
AWG
16 14
X
X
X
X
Terminal Series No.
33000
33011
Wire Size
AWG mm²
14 2.00
16 1.27
14 2.00
16 1.27
Insulation Crimp
Height
Width
mm
In.
mm
In.
2.70-2.90 .106-.114 2.70-2.90 .106-.114
2.10-2.30 .083-.091 2.50-2.70 .098-.106
2.70-2.90 .106-.114 2.70-2.90 .106-.114
2.10-2.30 .083-.091 2.50-2.70 .098-.106
Pull Force
Minimum
N
180.0
120.0
180.0
120.0
Lb.
40.50
27.00
40.50
27.00
OPERATION
Open the tool by squeezing the handles together, at the end of the closing stroke, the ratchet mechanism will
release the handles, and the hand tool will spring open.
Crimping Terminals
1. Lift the wire stop blades up.
WIRE STOP
BLADES
2. Insert the terminal fully into the correct die profile and the
locator slot until the terminal is fully seated and stops.
3. Bring down the wire stop blades. Make sure the wire stop
blades are fully seated on the terminal behind the conductor
grip section.
4. Slide the pre-stripped wire into the terminal; make sure to aim
the wire brush towards the tip point on the wire stop blade. See
Figure 1. Align the wire so that it is parallel and sitting into the
PRE-STRIPPED
LOCATOR ^TERMINAL
WIRE
terminal. Maintain a light and constant pressure on the wire
that is seated in the terminal at all times. (Do not let go of the
Figure 1
wire.) Be sure to hold the wire and terminal in place until the terminal is fully crimped. See Figure 2.
Doc No: ATS-638112400 Release Date: 01-21-03
Revision: D
Revision Date: 09-29-09
UNCONTROLLED COPY
Page 2 of 5