63811-2400 Datasheet, PDF (1/5 Pages) Molex Electronics Ltd. – Hand Crimp Tool Specification Sheet

Hand Crimp Tool for 1.50mm (.591") Pitch, MX150 Blade Crimp Terminals
Hand Crimp Tool
Specification Sheet
Order No. 63811-2400
FEATURES
% A full cycle ratcheting hand tool ensures complete crimps
% Ergonomically designed soft handles
% Precisely designed crimping profiles with simple contact positioning
% Easy handling due to outstanding force ratio
TYPE 4A
SCOPE
Products: 1.50mm (.591") Pitch, MX150 Blade Male Crimp Terminals, 14-16 AWG.
Terminal Series No.
Terminal Order No.
●Reel
Wire Size Insulation Diameter
AWG mm² mm
In.
Strip Length
mm
In.
33000
33000-0001 33000-1001 14 2.00 2.54-2.69 .100-.106 4.70-5.60 .185-.220
33000-0002 33000-1002 16 1.27 2.18-2.34 .086-.092 4.70-5.60 .185-.220
33011-0001 33011-0002
33011-1002 33011-2003 14 2.00 2.54-2.69 .100-.106 4.70-5.60 .185-.220
33011
33011-3003
33011-0003 33011-0004
33011-1004 33011-2002 16 1.27 2.18-2.34 .086-.092 4.70-5.60 .185-.220
33011-3002
●Customer to cut off terminal from reel: 0.10mm (.010”) maximum Cut-off Tab.
Terminals were validated per USCAR-21 using the following wire specifications:
M1L-123A (TXL), M1L-135A1 (UTX), and M1L-126A1 (metric-TXL).
Customers are required to complete validation testing if tooling purchased outside Molex Inc.
and / or wire specifications are different than above.
DEFINITION OF TERMS
BEND UP
BRUSH
WIRE BEND
ROLLING
TWISTING
BEND
DOWN
WIRE BRUSH MUST BE
0.30
FLUSH OR BELOW TOP
OF CONDUCTOR CRIMP
CUT-OFF
TAB
WIRE BEND
STRIP LENGTH
SEAM
INSULATION
CRIMP
BELL MOUTH
THIS AREA
TERMINAL WIDTH
NOT TO EXCEED
2.65mm AFTER CRIMP
CRIMP
HEIGHT
CONDUCTOR
CRIMP
Doc No: ATS-638112400 Release Date: 01-21-03
Revision: D
Revision Date: 09-29-09
UNCONTROLLED COPY
Page 1 of 5