63819-6970 Datasheet, PDF (4/5 Pages) Molex Electronics Ltd. – Application Tooling Specification Sheet

Hand Crimp Tool for VersaBlade™ Industry standard .070" Terminals
5. Pull force should be used as the final criteria for an acceptable crimp. Pull force is measured with no
influence from the insulation crimp. The insulation should be stripped long (1/2 in.) so the insulation grips
on the terminal do not grip the wire insulation or the conductor. Refer to Molex Quality Crimping
Handbook 63800-0029 for additional information on crimping and crimp testing.
6. Molex does not certify crimp hand tools.
CAUTION: Molex crimp specifications are valid only when used with Molex terminals and tooling.
Applications for the Modular Crimp Head
WARNING: NEVER operate, service, install, or adjust this Modular Crimp Head without proper instruction
and without first reading and understanding the instructions in the proper Manual or Specification Sheet.
See Chart below for the correct Manual or Specification Sheet.
WARNING: NEVER install tooling or service this tool while it is into any power source. Disconnect the
power by unplugging or turn off the Actuator from its power source.
CAUTION: Keep fingers away from the crimping area when operating this tool. It may cause severe injury.
CAUTION: Wear safety glasses when operating or serving this tool.
The chart below shows all applications for this Modular Crimp Head.
Modular Crimp Head
Order No.
63819-6970
Tool
Order no.
63816-0000
63816-0050
63816-0200
63816-0250
63816-0100
Tool
Description
Hand Crimp Frame (Short)
Hand Crimp Frame (Long)
Battery Power Tool (110 V)
Battery Power Tool (220 V)
Air Power Tool
Adapter
Order No.
N/A
N/A
63816-0600
63816-0600
63816-0700
Adapter
Description
N/A
N/A
Battery Power Crimp Adapter
Battery Power Crimp Adapter
Air Power Crimp Adapter
Figure
No.
3
3
4
4
5
Applications for the Modular Crimp Head
Hand Crimp Tool
Battery Powered Tool
Air Powered Tool
LOCKING
PINS
MODULAR
CRIMP
HEAD
HAND CRIMP
FRAME LONG
OR SHORT
Figure 3
LOCKING
PINS
MODULAR
CRIMP
HEAD
LOCKING PINS
BATTERY
POWER
B
E
Figure 4
BATTERY
POWERED
TOOL
LOCKING
PINS
AIR
POWER
TOOL
MODULAR
CRIMP HEAD
AIR POWER
CRIMP
ADAPTER
LOCKING
PINS
Figure 5
Doc No: ATS-6381969HM Release Date: 08-03-10
Revision: A
Revision Date: 08-03-10
UNCONTROLLED COPY
Page 4 of 5