0638132300 Datasheet, PDF (2/2 Pages) Molex Electronics Ltd. – Extractor Tool Instruction Sheet

Extractor Tool for 1.50mm (.059") CP Crimp Terminals
3. Position the blades of the extraction tool into the two small cavities of the slot in the front face of the housing as
shown in Figure 2. Use the identifying markings on both the front and back of the connector to locate the opening
used to extract the crimped wire.
SECONDARY
LOCK OPEN
CRIMPED WIRE
PUSH
EXTRACTOR
TOOL INTO
FRONT FACE
MARKINGS ON BACK
AND FRONT OF HOUSING
Figure 2
ORIENT BLADES INTO
HOUSING CAVITIES
4. Push extractor tool into the desired slot until it clicks or comes to a stop. Do not force the extractor tool any
further or there can be damage to the housing.
5. Gently push the wire forward towards the housing and then pull out of the CMC housing.
6. Molex does not offer repair parts for Extractor Tools due to the inexpensive nature of these tools.
Americas Headquarters
Lisle, Illinois 60532 U.S.A.
1-800-78MOLEX
[e-mail]
Far East North Headquarters
Yamato, Kanagawa, Japan
81-462-65-2324
[e-mail]
Far East South Headquarters
Jurong, Singapore
65-6-268-6868
[e-mail]
European Headquarters
Munich, Germany
49-89-413092-0
[e-mail]
Visit our Web site at http://www.molex.com
Corporate Headquarters
2222 Wellington Ct.
Lisle, IL 60532 U.S.A.
630-969-4550
Fax: [phone]
Doc No: ATS-638132300 Release Date: 04-11-07
Revision: B
Revision Date: 01-27-09
UNCONTROLLED COPY
Page 2 of 2