03-09-1031 Datasheet, PDF (3/3 Pages) Molex Electronics Ltd. – PLUG AND RECEPTACLE POWER CONNECTORS

PRODUCT SPECIFICATION
5.2 MECHANICAL REQUIREMENTS
ITEM DESCRIPTION TEST CONDITION
Mate and unmate connector (male to female)
4
Connector Mate
and
Unmate Forces
at a rate of 25 ± 6 mm (1 ± ¼ inch) per
minute for a total of 25 cycles. Initial mate
forces to be measured. Unmate forces to be
measured after 25 cycles.
REQUIREMENT
15.6 N (3.5 lbf)
MAXIMUM insertion force
4.4 N (1 lbf)
MINIMUM withdrawal force
Terminal
Axial pullout force on the terminal in the
5 Retention Force housing at a rate of 25 ± 6 mm (1 ± ¼ inch)
(in Housing)
per minute.
89 N (20 lbf)
MINIMUM retention force
MINIMUM pullout forces:
14 AWG 178 N (40 lbf)
6
Wire
Pullout Force
(Axial)
Apply an axial pullout force on the wire at a
rate of 25 ± 6 mm (1 ± ¼ inch).
16 AWG 156 N (35 lbf)
18 AWG 133 N (30 lbf)
20 AWG 89 N (20 lbf)
22 AWG 62 N (14 lbf)
24 AWG 36 N (8 lbf)
7
Terminal
Insertion Force
(into Housing)
Apply an axial insertion force on the terminal
22N (5 lbf)
at a rate of 25 ± 6 mm (1 ± ¼ inch).
MAXIMUM insertion force
5.3 ENVIRONMENTAL REQUIREMENTS
ITEM DESCRIPTION TEST CONDITION
Mate connectors; expose to temperature
8
Thermal
Cycling
cycling between –25°C and 70°C for 500
cycles with a dwell time of 30 minutes at
each extreme. Measurements to be taken
initially and after every 100 cycles.
REQUIREMENT
10 milliohms MAXIMUM
(change from initial)
&
Visual: No Damage
6.0 PACKAGING
Parts shall be packaged to protect against damage during handling, transit and storage. See the
appropriate sales drawings for additional information on packaging requirements.
REVISION: ECR/ECN INFORMATION:
B
EC No:UCR#2003-0230
DATE:2002 / 08/ 07
DOCUMENT NUMBER:
PS-43660-9999
TITLE:
PRODUCT SPECIFICATION
STANDARD .093 SERIES
PLUGS & RECEPTACLES
CREATED / REVISED BY:
CHECKED BY:
BWIRKUS 10/4/01
BWIRKUS 10/4/01
SHEET No.
3 of 3
APPROVED BY:
SFRY 10/5/01
TEMPLATE FILENAME: PRODUCT_SPEC[SIZE_A](V.1).DOC