MWC Datasheet, PDF (2/2 Pages) MERITEK ELECTRONICS CORPORATION – Snap-In Aluminum Electrolytic Capacitors

MECHANICAL DIMENSIONS:
2.10 [.083]
MAX
0.80 [.031]
MAX
0.70 [.028]
MXX.XXX
SYYWWL
1.70 [.067]
MAX
3
4
2
1
0.50 [.020]
PIN 1 DESIGNATOR LOCATED
IN THIS AREA
0.60 [.024]
DIMENSION IN BRACKETS ARE IN INCHES
EXTERNAL BYPASS CAPACITOR IS RECOMMENDED
1.50 [.059]
0.50 [.020]
1.00 [.039]
0.75 [.030]
SUGGESTED
LAND PATTERN
0.65 [.026]
PIN 1
PIN 2
PIN 3
PIN 4
PIN CONNECTIONS
TRI-STATE OR NO CONNECTION
OUTPUT
CASE GROUND
SUPPLY VOLTAGE
ENVIRONMENTAL/MECHANICAL SPECIFICATION:
Shock
Solderability
Vibration
Gross Leak Test
Fine Leak Test
Reflow Solder
MIL-STD-883, Meth 2002, Cond B
MIL-STD-883, Meth 2003
MIL-STD-883, Meth 2007, Cond A
MIL-STD-883, Meth 1014, Cond C
MIL-STD-883, Meth 1014, Cond A
+260ºC for 10 sec max
TAPE AND REEL DIMENSIONS:
MARKING DETAIL:
Line 1 = MXX.XXX
M
= MMD COMPONENTS
XX.XXX = Frequency in MHZ
Line 2 = SYYWWL
S = Internal Code
YYWW = 4 Digit Date Code (Year / Week)
L = Denotes RoHS Compliant
Pin 1 Designator
PITCH
TAPE WIDTH
B0
A0
K0
REEL DIA
Q1 Q2
Q3 Q4
Q1 Q2
Q3 Q4
DIRECTION OF FEED
PITCH
TAPE WIDTH
REEL DIA
QTY PER REEL
PIN 1 ORIENT.
4.0
8.0
180
1000
Q1
NOTES: UNLESS OTHERWISE SPECIFIED
1. Applicable Standards / Specifications
ANSI Y14.5M, Dimensions and Tolerances
EIA-481-B, 8 mm through 200mm Embossed Carrier Taping and 8 mm and 12 mm
Punched Carrier Taping of Surface Mount Components for Automatic Handling.
2. Dimensions are in millimeters.
3. Tolerances are ±0.1 mm unless otherwise specified.
4. Do not scale drawing.
MMD Components, 30400 Esperanza, Rancho Santa Margarita, CA, 92688
Phone: [phone], Fax: [phone], www.mmdcomp.com
[e-mail]
In the event of conflict, the requirements of this specification shall govern
Specification Subject to change without notice
Revision:
Pb RoHS
Free Compliant
MWC111509A
Page 2 of 2