MH64S64APFH-6 Datasheet, PDF (7/52 Pages) Mitsubishi Electric Semiconductor – 4294967296-BIT (67108864 - WORD BY 64-BIT)SynchronousDRAM

Preliminary Spec.
Some contents are subject to change without notice.
MITSUBISHI LSIs
MH64S64APFH-6,-6L,-7,-7L
4294967296-BIT (67108864 - WORD BY 64-BIT)SynchronousDRAM
BASIC FUNCTIONS
The MH64S64APFH provides basic functions,bank(row)activate,burst read / write,
bank(row)precharge,and auto / self refresh.
Each command is defined by control signals of /RAS,/CAS and /WE at CK rising edge.
In addition to 3 signals,/S,CKE and A10 are used as chip select,refresh option,and
precharge option,respectively.
To know the detailed definition of commands please see the command truth table.
CK
/S
/RAS
/CAS
/WE
CKE
A10
Chip Select : L=select, H=deselect
Command
Command
Command
def ine basic commands
Ref resh Option @ref resh command
Precharge Option @precharge or read/write command
Activate(ACT) [/RAS =L, /CAS = /WE =H]
ACT command activates a row in an idle bank indicated by BA.
Read(READ) [/RAS =H,/CAS =L, /WE =H]
READ command starts burst read from the active bank indicated by BA.First output
data appears after /CAS latency. When A10 =H at this command,the bank is
deactivated after the burst read(auto-precharge,READA).
Write(WRITE) [/RAS =H, /CAS = /WE =L]
WRITE command starts burst write to the active bank indicated by BA. Total data
length to be written is set by burst length. When A10 =H at this command, the bank is
deactivated after the burst write(auto-precharge,WRITEA).
Precharge(PRE) [/RAS =L, /CAS =H,/WE =L]
PRE command deactivates the active bank indicated by BA. This command also
term inates burst read / write operation. When A10 =H at this command, both banks
are deactivated(precharge all, PREA).
Auto-Refresh(REFA) [/RAS =/CAS =L, /WE =CKE =H]
REFA command starts auto-refresh cycle. Refresh address including bank address
are generated internally. After this command, the banks are precharged automatically.
MIT-DS-0392-0.1
MITSUBISHI
ELECTRIC
( 7 / 52 )
16.Apr.2000