M37733M4LXXXHP Datasheet, PDF (29/31 Pages) Mitsubishi Electric Semiconductor – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER

80P6S (80-PIN QFP) MARK SPECIFICATION FORM
80P6D, 80P6Q (80-PIN Fine-pitch QFP)
Mitsubishi IC catalog name
Please choose one of the marking types below (A, B, C), and enter the Mitsubishi IC catalog name and the special mark (if needed).
A. Standard Mitsubishi Mark
60
61
41
40
Mitsubishi product number
(6-digit, or 7-digit)
Mitsubishi IC catalog name
Mitsubishi IC catalog name
80
21
1
20
B. Customer’s Parts Number + Mitsubishi IC Catalog Name
60
41
61
80
1
40
21
20
Customer’s Parts Number
Note : The fonts and size of characters are standard Mitsubishi type.
Mitsubishi IC catalog name
Notes 1 : The mark field should be written right aligned.
2 : The fonts and size of characters are standard
Mitsubishi type.
3 : Customer ’s parts number can be up to 10 alphanu-
meric characters for capital letters, hyphens, commas,
periods and so on.
4 : If the Mitsubishi logo is not required, check the box
below.
Mitsubishi logo is not required
C. Special Mark Required
60
61
41
40
80
1
21
20
5 : The allocation of Mitsubishi IC catalog name and
Mitsubishi product number is different on the package
owing to the number of Mitsubishi IC catalog name’s
characters, and the requiring Mitsubishi logo or not.
Notes 1 : If Special mark is to be printed, indicate the desired
layout of the mark in the left figure. The layout will be
duplicated technically as close as possible. Mitsubishi
product number (6-digit, or 7-digit) and Mask ROM
number (3-digit) are always marked for sorting the
products.
2 : If special character fonts (e.g., customer’s trade mark
logo) must be used in Special Mark, check the box be-
low.
For the new special character fonts, a clean font origi-
nal (ideally logo drawing) must be submitted.
Special character fonts required