MT8889C Datasheet, PDF (3/18 Pages) Mitel Networks Corporation – Integrated DTMFTransceiver with Adaptive Micro Interface

Functional Description
The MT8889C/MT8889C-1 Integrated DTMF
Transceiver consists of a high performance DTMF
receiver with an internal gain setting amplifier and a
DTMF generator, which employs a burst counter to
synthesize precise tone bursts and pauses. A call
progress mode can be selected so that frequencies
within the specified passband can be detected. The
adaptive micro interface allows microcontrollers,
such as the 68HC11, 80C51 and TMS370C50, to
access the MT8889C/MT8889C-1 internal registers.
Input Configuration
The input arrangement of the MT8889C/MT8889C-1
provides a differential-input operational amplifier as
well as a bias source (V_Ref), which is used to bias the
inputs at V_DD/2. Provision is made for connection of
a feedback resistor to the op-amp output (GS) for
gain adjustment. In a single-ended configuration, the
input pins are connected as shown in Figure 3.
Figure 4 shows the necessary connections for a
differential input configuration.
Receiver Section
Separation of the low and high group tones is
achieved by applying the DTMF signal to the inputs
of two sixth-order switched capacitor bandpass
filters, the bandwidths of which correspond to the low
and high group frequencies (see Table 1). The filters
also incorporate notches at 350 Hz and 440 Hz for
exceptional dial tone rejection. Each filter output is
followed by a single order switched capacitor filter
section, which smooths the signals prior to limiting.
Limiting is performed by high-gain comparators
which are provided with hysteresis to prevent
detection of unwanted low-level signals. The outputs
of the comparators provide full rail logic swings at
the frequencies of the incoming DTMF signals.
IN+
IN-
C
R_IN
R_F
GS
VOLTAGE GAIN
(A_V) = R_F / R_IN
V_Ref
MT8889C/
MT8889C-1
Figure 3 - Single-Ended Input Configuration
MT8889C/MT8889C-1
C1
R1
C2
R4
R5
R3
R2
DIFFERENTIAL INPUT AMPLIFIER
C1 = C2 = 10 nF
R1 = R4 = R5 = 100 kΩ
R2 = 60kΩ, R3 = 37.5 kΩ
R3 = (R2R5)/(R2 + R5)
VOLTAGE GAIN
(A_V diff) - R5/R1
INPUT IMPEDANCE
(Z_INdiff) = 2 R1² + (1/ωC)²
IN+
IN-
GS
V_Ref
MT8889C/
MT8889C-1
Figure 4 - Differential Input Configuration
F_LOW
F_HIGH
DIGIT D₃
D₂
D₁
D₀
697 1209
1
0001
697 1336
2
0010
697 1477
3
0011
770 1209
4
0100
770 1336
5
0101
770 1477
6
0110
852 1209
7
0111
852 1336
8
1000
852 1477
9
1001
941 1336
0
1010
941 1209
*
1011
941 1477
#
1100
697 1633
A
1101
770 1633
B
1110
852 1633
C 1111
941 1633
D 0000
0= LOGIC LOW, 1= LOGIC HIGH
Table 1. Functional Encode/Decode Table
4-109