YSF-272 Datasheet, PDF (4/5 Pages) Mini-Circuits – Flat Gain Amplifier

™
Flat Gain Amplifier
Characterization Test Circuit
Vs (Supply Voltage)
YSF-272+
RF-IN
4
5
3
RF-OUT
TB-589+
Fig 1. Block Diagram of Test Circuit used for characterization. (DUT soldered on Mini-Circuits Characterization Test Fixture TB-589+)
Gain, Return loss, Output power at 1dB compression (P1 dB), Output IP3 (OIP3) and Noise Figure measured using Agilent’s N5242A
PNA-X microwave network analyzer.
Conditions:
1. Gain: Pin= -25dBm
2. Output IP3 (OIP3): Two tones, spaced 10 MHz apart, 2.5 dBm/tone at output.
Recommended Application Circuit
(refer to evaluation board for PCB Layout and component values)
Vs
RF-IN
4
5
C1
3
RF-OUT
Paddle
Fig 2. Recommended Application Circuit
Product Marking
YSF
index over pin 1
Mini-Circuits^®
ISO 9001 ISO 14001 AS 9100 CERTIFIED
P.O. Box 350166, Brooklyn, New York 11235-0003 [phone] Fax [phone] The Design Engineers Search Engine
For detailed performance specs
& shopping online see web site
® _{Provides ACTUAL Data Instantly at minicircuits.com}
IF/RF MICROWAVE COMPONENTS
Notes: 1. Performance and quality attributes and conditions not expressly stated in this specification sheet are intended to be excluded and do not form a part of this specification sheet. 2. Electrical specifications
and performance data contained herein are based on Mini-Circuit’s applicable established test performance criteria and measurement instructions. 3. The parts covered by this specification sheet are subject to
Mini-Circuits standard limited warranty and terms and conditions (collectively, “Standard Terms”); Purchasers of this part are entitled to the rights and benefits contained therein. For a full statement of the Standard
Terms and the exclusive rights and remedies thereunder, please visit Mini-Circuits’ website at www.minicircuits.com/MCLStore/terms.jsp.
Page 4