GVA-62 Datasheet, PDF (4/5 Pages) Mini-Circuits – Monolithic Amplifier

Monolithic InGap HBT MMIC Amplifier
Characterization Test Circuit
Vcc (Supply voltage)
GVA-62+
RF-IN
BLK-18+
1
3 ^+5V
2,4
DUT
TB-313
Bias-Tee
ZX85-12G-S+
RF-OUT
Fig 1. Block Diagram of Test Circuit used for characterization. (DUT soldered on Mini-Circuits Characterization test board TB-313)
Gain, Return loss, Output power at 1dB compression (P1 dB) , output IP3 (OIP3) and noise figure measured using Agilent’s N5242A
PNA-X microwave network analyzer.
Conditions:
1. Gain and Return loss: Pin= -25dBm
2. Output IP3 (OIP3): Two tones, spaced 1 MHz apart, 0 dBm/tone at output.
Recommended Application Circuit
Cblock
IN
1
4 ^Ibias _RFC
3
Vd _Cblock
2
Vcc
Cbypass
OUT
Fig 2. Test Board includes case, connectors, and components soldered to PCB
Product Marking
V62
Notes
A. Performance and quality attributes and conditions not expressly stated in this specification document are intended to be excluded and do not form a part of this specification document.
B. Electrical specifications and performance data contained in this specification document are based on Mini-Circuit’s applicable established test performance criteria and measurement instructions.
C. The parts covered by this specification document are subject to Mini-Circuits standard limited warranty and terms and conditions (collectively, “Standard Terms”); Purchasers of this part are entitled
to the rights and benefits contained therein. For a full statement of the Standard Terms and the exclusive rights and remedies thereunder, please visit Mini-Circuits’ website at www.minicircuits.com/MCLStore/terms.jsp
Mini-Circuits^®
www.minicircuits.com P.O. Box 350166, Brooklyn, NY 11235-0003 [phone] [e-mail]
Page 4 of 4