UM9301_05 Datasheet, PDF (1/5 Pages) Microsemi Corporation – Commercial Attenuator Diode

UM9301/UM9301SM
Commercial Attenuator Diode
PRODUCT PREVIEW
DESCRIPTION
The UM9301 PIN Diode utilizes special
overall chip geometry with an extremely
thick intrinsic “I” region, to offer unique
capabilities in both RF switch and
attenuator applications.
Volume production also makes the diode
an economical choice suitable for many
commercial low power equipments.
The UM9301 has been designed for use
in bridged TEE attenuator circuits
commonly utilized for gain and slope
control in CATV amplifiers.
Low distortion and high dynamic range are
characteristic of the diodes’ outstanding
performance.
The UM9301 is also appropriate for
switch applications, when little or no bias
voltage is available. Frequent applications
occur in portable 12 volt-powered
communications equipments, operating at
frequencies as low as 2 MHz.
IMPORTANT:Forthemostcurrentdata,consultMICROSEMI’s website: http://www.microsemi.com
ABSOLUTE MAXIMUM RATINGS AT 25º C
(UNLESS OTHERWISE SPECIFIED)
Rating
Symbol
Value
Reverse Voltage
Reverse Current
Average Power Dissipation (1, 2)
VR
75
IR
10
PA
1.0
Storage Temperature
T stg
-65 to 175
Unit
Volts
µA
Watts
ºC
Operating Temperature
T op
-65 to 175 ºC
KEY FEATURES
Specified low distortion
Low distortion properties at low
reverse bias
Resistance specified at 3 current
points
High reliability fused-in-glass
construction
APPLICATIONS/BENEFITS
Little or no Bias required.
Operates as low as 2MH_Z.
Available in leaded or surface
mount packages.
UM9301SM
UM9301
UM9301SM
(1) Mounted on 2” square by 0.06’ thick FR4 board with a 1” x 1” square 2-ounce copper pattern..
(2) Lead ½ inch. (12.7mm) Total to 25°C Contact.
Copyright  2005
Rev. A, 2005-07-05
Microsemi
75 Technology Drive, Lowell, MA. 01851, 978-442-5600, Fax: [phone]
Page 1