M25PX64-VMF Datasheet, PDF (42/56 Pages) Micron Technology – Micron M25PX64 Serial Flash Embedded Memory

Micron M25PX64 Serial Flash Embedded Memory
Power-Up/Down and Supply Line Decoupling
Figure 30: Power-Up Timing
VCC
VCC,max
PROGRAM, ERASE, and WRITE commands are rejected by the device
Chip selection not allowed
VCC,min
VWI
RESET state
of the
device
t_VSL
READ access allowed
t_PUW
Device fully
accessible
Time
After power-up, the device is in the following state:
• Standby power mode (not the deep power-down mode)
• Write enable latch (WEL) bit is reset
• Write in progress (WIP) bit is reset
• Write lock bit = 0
• Lock down bit = 0
Normal precautions must be taken for supply line decoupling to stabilize the V_CC sup-
ply. Each device in a system should have the V_CC line decoupled by a suitable capacitor
close to the package pins; generally, this capacitor is of the order of 100 nF.
At power-down, when V_CC drops from the operating voltage to below the POR threshold
voltage V_WI, all operations are disabled and the device does not respond to any instruc-
tion.
Note: If power-down occurs while a WRITE, PROGRAM, or ERASE cycle is in progress,
some data corruption may result.
PDF: 09005aef845665ac
m25px64.pdf - Rev. B 3/13 EN
42
Micron Technology, Inc. reserves the right to change products or specifications without notice.
© 2013 Micron Technology, Inc. All rights reserved.