MT9M001 Datasheet, PDF (1/32 Pages) Micron Technology – 1/2-Inch Megapixel CMOS Digital Image Sensor

MT9M001 - 1/2-Inch Megapixel Digital Image Sensor
Features
1/2-Inch Megapixel CMOS Digital Image Sensor
MT9M001C12STM (Monochrome)
For the latest data sheet, refer to Micron’s Web site: www.micron.com\imaging
Features
• DigitalClarity™ CMOS Imaging Technology
• Array Format (5:4): 1,280H x 1,024V (1,310,720 active
pixels). Total (incl. dark pixels): 1,312H x 1,048V
(1,374,976 pixels)
• Frame Rate: 30 fps progressive scan; programmable
• Shutter: Electronic Rolling Shutter (ERS)
• Window Size: SXGA; programmable to any smaller
format (VGA, QVGA, CIF, QCIF, etc.)
• Programmable Controls: Gain, frame rate, frame
size
Applications
• Digital still cameras
• Digital video cameras
• PC cameras
General Description
The Micron^® Imaging MT9M001 is an SXGA-format
with a 1/2-inch CMOS active-pixel digital image sen-
sor. The active imaging pixel array of 1,280H x 1,024V. It
incorporates sophisticated camera functions on-chip
such as windowing, column and row skip mode, and
snapshot mode. It is programmable through a simple
two-wire serial interface.
This megapixel CMOS image sensor features Digital-
Clarity—Micron’s breakthrough low-noise CMOS
imaging technology that achieves CCD image quality
(based on signal-to-noise ratio and low-light sensitiv-
ity) while maintaining the inherent size, cost, and inte-
gration advantages of CMOS.
Table 1: Key Performance Parameters
Parameter
Typical Value
Optical format
Active imager size
Active pixels
Pixel size
Shutter type
Maximum data rate/
master clock
Frame SXGA
rate (1280 x 1024)
ADC resolution
Responsivity
Dynamic range
SNR_MAX
Supply voltage
Power consumption
Operating temperature
Packaging
1/2-inch (5:4)
6.66mm(H) x 5.32mm(V)
1,280H x 1,024V
5.2µm x 5.2µm
Electronic rolling shutter (ERS)
48 MPS/48 MHz
30 fps progressive scan;
programmable
10-bit, on-chip
2.1 V/lux-sec
68.2dB
45dB
3.0V−3.6V, 3.3V nominal
325mW at 3.3V;
Standby 275µW
0°C to +70°C
48-pin CLCC
The sensor can be operated in its default mode or pro-
grammed by the user for frame size, exposure, gain set-
ting, and other parameters. The default mode outputs
an SXGA-size image at 30 frames per second (fps). An
on-chip analog-to-digital converter (ADC) provides 10
bits per pixel. FRAME_VALID and LINE_VALID signals
are output on dedicated pins, along with a pixel clock
that is synchronous with valid data.
Ordering Information
Table 2: Available Part Numbers
Part Number
MT9M001C12STM
Description
46-pin CLCC
80a3e031
MT9M001_DS_1.fm - Rev. C 7/05 EN
1
Micron Technology, Inc., reserves the right to change products or specifications without notice.
©2004 Micron Technology, Inc. All rights reserved.
Products and specifications discussed herein are subject to change by Micron without notice.