WRA-ZMD-20W Datasheet, PDF (3/3 Pages) Microdc power Technology Co., Ltd – 20W,WIDEINPUT, ISOLATED®ULATEDDUAL/SINGLEOUTPUTDC-DCCONVERTER

WRA-ZMD-20W＆WRB-ZMD -20W Series
OUTLINE DIMENSIONS ＆ FOOTPRINT DETAILS
MECHANICAL DIMENSIONS
RECOMMENDED FOOTPRINT
Note:
Unit:mm[inch]
Pin section tolerances:±0.10mm[±0.004inch]
General tolerances:±0.25mm[±0.010inch]
FOOTPRINT DETAILS
Pin
1
2
3
4
5
NC:No connection
Single
GND
Vin
+Vo
NC
0V
Dual
GND
Vin
+Vo
0V
-Vo
RECOMMENDED FOOTPRINT
TUBE OUTLINE DIMENSIONS
When the environment temperature is higher than
71℃, the product output power should be less
then 60% of the rated power.
Note:
No parallel connection or plug and play.
Unit :mm[inch]
General tolerances:±0.50mm[±0.020inch]
Use dual output simultaneously,forbid pening
L=230mm[9.055inch] Tube Quantity: 7pcs
output pin (0V) to use as single output.
Note:
1. The load shouldn't be less than 10%, otherwise ripple will increase dramatically.
2. Operation under 10% load will not damage the converter; However, they may not meet all specification listed.
3. All specifications measured at Ta=25°C, humidity<75%, nominal input voltage and rated output load unless otherwise
specified.
4. In this datasheet, all the test methods of indications are based on corporate standards.
5. Only typical models listed, other models may be different, please contact our technical person for more details.
http://www.microdc.cn Technical Enquiries-Email:[e-mail] Tel:[phone] Page 3 of 3