F-XT-1W Datasheet, PDF (3/3 Pages) Microdc power Technology Co., Ltd – 1W, FIXEDINPUT, ISOLATED SINGLE/DUALOUTPUTDC-DCCONVERTER

OUTLINE DIMENSIONS ＆ FOOTPRINT DETAILS
MECHANICAL DIMENSIONS
F-XT-1W＆E-XT-1W Series
SOLDER PAD DIMENSION
Note:
Unit:mm[inch]
Pin section tolerances:±0.10mm[±0.004inch]
General tolerances:±0.25mm[±0.010inch]
FOOTPRINT DETAILS
Dimensions in [mm], () = Inch
Pin pitch tolerances: ±0.13 (±0.005)
Other tolerances: ±0.25 (±0.01)
TUBE OUTLINE DIMENSIONS
Pin
Single
1
-Vin(GND)
2
+Vin
3
No con.
5
-Vout
6
No con.
7
No con.
8
+Vout
10
No con.
11
No con.
12
No con.
No con.=Pin to be isolated from circuitry
Dual
-Vin(GND)
+Vin
No con.
Common
-Vout
No con.
+Vout
No con.
No con.
No con.
Unless otherwise stated all dimensions in mm±0.5 (inches ±0.02).
Tube length : 475±2.0 (18.70±0.07).
Tube Quantity :25
Specifcations can be changed any time without notice.
No parallel connection or plug and play.
Note:
1. The load shouldn't be less than 10%, otherwise ripple will increase dramatically.
2. Operation under 10% load will not damage the converter; However, they may not meet all specification listed.
3. All specifications measured at Ta=25°C, humidity<75%, nominal input voltage and rated output load unless otherwise
specified.
4. In this datasheet, all the test methods of indications are based on corporate standards.
5. Only typical models listed, other models may be different, please contact our technical person for more details.
http://www.microdc.cn Technical Enquiries-Email:[e-mail] Tel:[phone] Page 3 of 3