F-XT-1W Datasheet, PDF (2/3 Pages) Microdc power Technology Co., Ltd – 1W, FIXEDINPUT, ISOLATED SINGLE/DUALOUTPUTDC-DCCONVERTER

F-XT-1W＆E-XT-1W Series
Output Specifications
Parameter
Voltage set accuracy
Regulation
Voltage balance (dual output
models, balanced load)
Temperature coefficient
– Input variation
– Load variation
Conditions
see graphs below
1.2 % / 1 % change Vin
see graphs below
± 1.0% max.
0.1 %/K
Ripple and noise (20 MHz Bandwidth)
100 mVp-p max.
Temperature coefficient
Short circuit protection
Capacitive load
± 0.02%/K max.
limited 0.5 sec. max.
3.3 VDC output models: 33µF max.
5 VDC output models: 33µF max.
12 VDC output models: 4.7µF max.
15 VDC output models: 2.2µF max.
±5 VDC output models: 10µF max.
±12 VDC output models: 2.2µF max.
±15 VDC output models: 2.2µF max.
General Specifications
Parameter
Temperature ranges
– Operating
Load derating
Humidity (non condensing)
– Case temperature
– Storage
(convection cooling)
Reliability, calculated MTBF
(MIL-HDBK-217F ground benign)
Isolation voltage (60 sec)
Isolation capacity
Isolation resistance
– Input/Output
– Input/Output(100kHz, 1V)
– Input/Output (500 VDC)
Switching frequency
Conditions
– 40 °C～+ 85 °C (no derating)
+95°C max.
– 55 °C～+ 125 °C
4%/K above +75°C
95 % rel. H max.
>2Mio h
3000 VDC
60 pF typ.
>1 GOhm
50 to 150 kHz (depending on load)
Output voltage variation dependent on load (at nominal input voltage)
All specifcations valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
http://www.microdc.cn Technical Enquiries-Email:[e-mail] Tel:[phone]
Page 2 of 3