PIC16C77X Datasheet, PDF (76/200 Pages) Microchip Technology – 28/40-Pin, 8-Bit CMOS Microcontrollers w/ 12-Bit A/D

PIC16C77X
8.2.10 I²C MASTER MODE REPEATED START
CONDITION TIMING
A Repeated Start condition occurs when the RSEN bit
(SSPCON2<1>) is programmed high and the I²C mod-
ule is in the idle state. When the RSEN bit is set, the
SCL pin is asserted low. When the SCL pin is sampled
low, the baud rate generator is loaded with the contents
of SSPADD<6:0>, and begins counting. The SDA pin
is released (brought high) for one baud rate generator
count (T_BRG). When the baud rate generator times out,
if SDA is sampled high, the SCL pin will be de-asserted
(brought high). When SCL is sampled high the baud
rate generator is re-loaded with the contents of
SSPADD<6:0> and begins counting. SDA and SCL
must be sampled high for one T_BRG. This action is then
followed by assertion of the SDA pin (SDA is low) for
one T_BRG while SCL is high. Following this, the RSEN
bit in the SSPCON2 register will be automatically
cleared, and the baud rate generator is not reloaded,
leaving the SDA pin held low. As soon as a start con-
dition is detected on the SDA and SCL pins, the S bit
(SSPSTAT<3>) will be set. The SSPIF bit will not be set
until the baud rate generator has timed-out.
Note 1: If RSEN is programmed while any other
event is in progress, it will not take effect.
Note 2: A bus collision during the Repeated Start
condition occurs if:
• SDA is sampled low when SCL goes from low to
high.
• SCL goes low before SDA is asserted low. This
may indicate that another master is attempting
to transmit a data "1".
Immediately following the SSPIF bit getting set, the
user may write the SSPBUF with the 7-bit address in
7-bit mode, or the default first address in 10-bit mode.
After the first eight bits are transmitted and an ACK is
received, the user may then transmit an additional eight
bits of address (10-bit mode) or eight bits of data (7-bit
mode).
8.2.10.6 WCOL STATUS FLAG
If the user writes the SSPBUF when a Repeated Start
sequence is in progress, then WCOL is set and the
contents of the buffer are unchanged (the write doesn’t
occur).
Note:
Because queueing of events is not
allowed, writing of the lower 5 bits of
SSPCON2 is disabled until the Repeated
Start condition is complete.
FIGURE 8-22: REPEAT START CONDITION WAVEFORM
Write to SSPCON2
occurs here.
SDA = 1,
SCL(no change)
SDA = 1,
SCL = 1
Set S (SSPSTAT<3>)
At completion of start bit,
hardware clear RSEN bit
and set SSPIF
SDA
Falling edge of ninth clock
End of Xmit
T_BRG
T_BRG
T_BRG
1st Bit
Write to SSPBUF occurs here.
T_BRG
SCL
T_BRG
Sr = Repeated Start
DS30275A-page 76
Advance Information
© 1999 Microchip Technology Inc.