24C32_04 Datasheet, PDF (7/14 Pages) Microchip Technology – 32K 5.0V I2C Smart Serial EEPROM

24C32
5.0 ACKNOWLEDGE POLLING
Since the device will not acknowledge during a write
cycle, this can be used to determine when the cycle is
complete (this feature can be used to maximize bus
throughput). Once the stop condition for a write com-
mand has been issued from the master, the device ini-
tiates the internally timed write cycle. ACK polling can
be initiated immediately. This involves the master send-
ing a start condition followed by the control byte for a
write command (R/W = 0). If the device is still busy with
the write cycle, then no ACK will be returned. If the
cycle is complete, then the device will return the ACK
and the master can then proceed with the next read or
write command. See Figure 5-1 for flow diagram
FIGURE 5-1: ACKNOWLEDGE POLLING
FLOW
Send
Write Command
Send Stop
Condition to
Initiate Write Cycle
Send Start
Send Control Byte
with R/W = 0
Did Device
Acknowledge
NO
(ACK = 0)?
YES
Next
Operation
6.0 READ OPERATION
Read operations are initiated in the same way as write
operations with the exception that the R/W bit of the
slave address is set to one. There are three basic
types of read operations: current address read, random
read, and sequential read.
6.1 Current Address Read
The 24C32 contains an address counter that maintains
the address of the last word accessed, internally incre-
mented by one. Therefore, if the previous access
(either a read or write operation) was to address n (n is
any legal address), the next current address read oper-
ation would access data from address n + 1. Upon
receipt of the slave address with R/W bit set to one, the
24C32 issues an acknowledge and transmits the eight
bit data word. The master will not acknowledge the
transfer but does generate a stop condition and the
24C32 discontinues transmission (Figure 6-1).
6.2 Random Read
Random read operations allow the master to access
any memory location in a random manner. To perform
this type of read operation, first the word address must
be set. This is done by sending the word address to the
24C32 as part of a write operation (R/W bit set to 0).
After the word address is sent, the master generates a
start condition following the acknowledge. This termi-
nates the write operation, but not before the internal
address pointer is set. Then the master issues the con-
trol byte again but with the R/W bit set to a one. The
24C32 will then issue an acknowledge and transmit the
eight bit data word. The master will not acknowledge
the transfer but does generate a stop condition which
causes the 24C32 to discontinue transmission
(Figure 6-2).
FIGURE 6-1: CURRENT ADDRESS READ
S
T
BUS ACTIVITY _A
MASTER
R
T
CONTROL
BYTE
S
T
DATA n
O
P
SDA LINE
S
P
BUS ACTIVITY
A
N
C
O
K
A
C
K
 2004 Microchip Technology Inc.
DS21061H-page 7