|
PIC18F86J90-I Datasheet, PDF (54/450 Pages) Microchip Technology – 64/80-Pin, High-Performance Microcontrollers with LCD Driver and nanoWatt Technology | |||
|
◁ |
PIC18F87J90 FAMILY
REGISTER 5-1: RCON: RESET CONTROL REGISTER
R/W-0
U-0
R/W-1
R/W-1
R-1
IPEN
â
CM
RI
TO
bit 7
R-1
R/W-0
R/W-0
PD
POR
BOR
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
â1â = Bit is set
U = Unimplemented bit, read as â0â
â0â = Bit is cleared
x = Bit is unknown
bit 7
IPEN: Interrupt Priority Enable bit
1 = Enable priority levels on interrupts
0 = Disable priority levels on interrupts (PIC16XXXX Compatibility mode)
bit 6
Unimplemented: Read as â0â
bit 5
CM: Configuration Mismatch Flag bit
1 = A configuration mismatch has not occurred
0 = A configuration mismatch has occurred (must be set in software after a Configuration Mismatch
Reset occurs)
bit 4
RI: RESET Instruction Flag bit
1 = The RESET instruction was not executed (set by firmware only)
0 = The RESET instruction was executed causing a device Reset (must be set in software after a
Brown-out Reset occurs)
bit 3
TO: Watchdog Time-out Flag bit
1 = Set by power-up, CLRWDT instruction or SLEEP instruction
0 = A WDT time-out occurred
bit 2
PD: Power-Down Detection Flag bit
1 = Set by power-up or by the CLRWDT instruction
0 = Set by execution of the SLEEP instruction
bit 1
POR: Power-on Reset Status bit
1 = A Power-on Reset has not occurred (set by firmware only)
0 = A Power-on Reset occurred (must be set in software after a Power-on Reset occurs)
bit 0
BOR: Brown-out Reset Status bit
1 = A Brown-out Reset has not occurred (set by firmware only)
0 = A Brown-out Reset occurred (must be set in software after a Brown-out Reset occurs)
Note 1: It is recommended that the POR bit be set after a Power-on Reset has been detected, so that subsequent
Power-on Resets may be detected.
2: If the on-chip voltage regulator is disabled, BOR remains â0â at all times. See Section 5.4.1 âDetecting
BORâ for more information.
3: Brown-out Reset is said to have occurred when BOR is â0â and POR is â1â (assuming that POR was set to
â1â by software immediately after a Power-on Reset).
DS39933D-page 54
ï£ 2010 Microchip Technology Inc.
|
▷ |